Abstract:Cu/MgO-Al2O3 (Mg/Al atomic ratio=1/1, 3/1, 4/1), Cu/MgO and Cu/Al2O3 catalysts with high Cu dispersions were prepared by an impregnation method using ethanol as solvent instead of water. Compared to water, ethanol as solvent was favorable not only for obtaining the high dispersions of the Cu clusters on the basic oxide supports, but also for retaining the basicity and structures of the supports during the catalyst preparation. The density of the basic sites for the dispersed Cu catalysts increased with increasing the MgO contents in the basic supports. These catalysts catalyzed glycerol hydrogenolysis to propylene glycol with a high selectivity (>90%), and showed slight deactivation in dioxane at 200 degrees C and 6.0 MPa H-2. Their reaction rates normalized by per exposed Cu atom increased with increasing the ratios of the basic sites to Cu atoms on the catalyst surfaces. The intrinsic hydrogenolysis activity of the Cu atoms were probed by N2O chemisorption-H-2 temperature programmed reduction, which did not change essentially with the Cu loadings (2-6 wt%) and the Mg/Al atomic ratios of the MgO-Al2O3 supports. Meanwhile, the basic sites alone on the supports were inactive for the glycerol conversion. Taken together, we propose a synergetic effect that the basic sites at the interfaces between the Cu sites and the supports assist the cleavage of alpha-C-H bonds of glycerol on the Cu surfaces leading to the faster dehydrogenation of glycerol to glyceraldehyde, a kinetically-relevant step in glycerol hydrogenolysis to propylene glycol. These active basic sites appear to be the Bronsted OH- sites, i.e. the hydroxyl groups bonded to the surface Mg2+ cations on MgO-Al2O3. The understanding on such synergy between the basic sites and Cu sites in glycerol hydrogenolysis provides a basis for the rational design of superior hydrogenolysis catalysts and selective removal of oxygen from biomass-derived feedstocks.

Study of catalytic oxidation of glycerol on cobalt- nickel phosphate molecular sieve under non- alkaline condition

In Situ Growth of Tungsten Oxide on Alumina to Boost the Catalytic Performance of Platinum for Glycerol Hydrogenolysis

Selective Oxidation of Glycerol in a Base-Free Aqueous Solution: A Short Review

Synthesis, Characterization and Catalytic Properties in Oxidation of Styrene over Cobalt-Substituted Microporous Nickel Phosphate Covsb-5

Low-temperature catalytic oxidation of glycerol into glyceric acid over Zr@MCM-41-supported Pt catalyst

Nickel aluminate spinel-derived catalysts for aqueous-phase hydrogenolysis of glycerol with in-situ hydrogen production: Effect of molybdenum doping

Selective oxidation of glycerol in a base-free aqueous solution over different sized Pt catalysts

Glycerol Hydrogenolysis over Supported Bimetallic Pt-Ni Catalyst

Selective Hydrogenolysis of Glycerol to Propylene Glycol on MgO-Al2O3 Dispersed Cu Catalysts

Kinetic Investigations of Glycerol Oxidation Reaction on Ni/C

Kinetics Decoupling Activity and Selectivity of Pt Nanocatalyst for Enhanced Glycerol Oxidation Performance

M/Al2O3 catalysts for hydrogen production via the steam reforming of glycerin

Glycerol steam reforming over Ni/γ-Al2O3 catalysts modified by metal oxides

Kinetics of Hydrogenolysis of Glycerol to Propylene Glycol over Cu-Zno-Al2o3 Catalysts

Glycerol Oxidation with Oxygen over Bimetallic Pt-Bi Catalysts under Atmospheric Pressure

PdAg/CoFe2O4 Bimetallic Catalyst with High Selectivity for Glyceraldehyde in Glycerol Selective Oxidation Reaction

Au‐Promoted Pt nanoparticles supported on MgO / SBA ‐15 as an efficient catalyst for selective oxidation of glycerol

Metal-organic frameworks-derived oxalate ligand modified NiCo hydroxides for enhanced electrochemical glycerol oxidation reaction

Studies on 1, 2-Propylene Glycol Oxidation to Prepare Methylglyoxal

Catalytic oxidation of phenol with H2O2 over VOx/GaSiAlOx catalyst

Influence of Synthesis Conditions on Catalytic Performance of Ni/CeO2 in Aqueous-Phase Hydrogenolysis of Glycerol without External Hydrogen Input