Abstract:This article presents dc magnetic flux bias suppression methods for a dual active bridge (DAB) converter in both steady state and transient process. The steady-state dc offset is caused by asymmetries of the circuit and power switches in practice, while the transient offset is caused by the sudden update of phase shift ratio. This dc bias will increase the conduction losses, lead to loss of zero voltage switching (ZVS), and even saturate the magnetic components. To prevent this risk, this article proposes methods to suppress the dc bias both in steady state and transient process. For steady-state dc bias suppression, the duty cycles of square voltages generated by the primary and secondary side H-bridges are regulated according to the dc bias current. The conditions to achieve zero dc bias and the small-signal model to regulate the dc bias current are derived. For transient dc bias suppression, the phase shift ratio variation is limited to ensure the peak inductor current within the safe operating range. Tunnel magnetoresistance (TMR) is employed to sense the currents, and an analog integration and sampling method is proposed to detect dc bias. Finally, the proposed method is verified through experimental results on a 3200-W DAB prototype.

DC Bias Elimination and Soft Switching in Transient State of Dual-Active-Bridge DC-DC Converter.

An Improved Three-Level Soft-Switching DC/DC Converter

A Novel Soft-Switching and Low-Conduction-loss Bidirectional DC-DC Converter

Soft switching characteristics of a novel and efficient DC/DC converter

Soft-Switching Single-Stage Current-Fed Full-Bridge Isolated Converter for High Power Ac/Dc Applications

A Novel Fully Zero-Voltage-Switching Phase-Shift Bidirectional Dc-Dc Converter

Soft-switching three-phase matrix based isolated AC-DC converter for DC distribution system

Steady-State and Transient DC Magnetic Flux Bias Suppression Methods for a Dual Active Bridge Converter

New methods to reduce circulating energy in dual active bridge converter

An Analog-based, Duty Cycle Modulation Method to Remove the DC Bias in the Transformer for a Dual Active Bridge Converter

Integrated Optimization of Dual-Active-Bridge DC–DC Converter with ZVS for Battery Charging Applications

Soft-switching and low conduction loss current-fed isolated bidirectional DC–DC converter with PWM plus dual phase-shift control

Modulation of 2/3-Level Dual-Active-Bridge DC-DC Converters for Soft-Switching and Minimum Current Stress.

A Soft-Switching Full-Bridge Inverter with High Efficiency

ZVS Control Strategy of Dual Active Bridge DC/DC Converter with Triple-Phase-shift Modulation Considering RMS Current Optimization

A Novel Soft Switching Bi-Directional Dc/Dc Converter

An Optimized Soft‐start Procedure of Dual Active Bridge Converter for Charging Current Suppression

Non-isolated stacked bidirectional soft-switching DC-DC converter with PWM plus phase-shift control scheme

Transient DC Bias and Universal Dynamic Modulation of Multiactive Bridge Converters

Circulating Current and ZVS-on of a Dual Active Bridge DC-DC Converter: A Review