Abstract:Continuum robots have attracted lots of attention due to their structural compliance, manipulation dexterity, and design compactness. To extend the application scenarios, a slender continuum robot, the CurviPicker, was developed for low-load medium-speed pick-and-place tasks in a previous study. To improve the payload capacity and positioning accuracy of the CurviPicker, a novel Continuum Delta Robot (CDR) was then proposed with three dual-continuum-joint translators in a preliminary investigation. However, the initial version of the CDR did not fully utilize the bending ranges of its continuum joints. In addition, while being modeled using the constant curvature assumption for the continuum joints, the CDR shows lowered positioning accuracy for heavier objects, as the CDR's continuum joints diverge from the assumed constant curvature shapes. In this paper, the design of the CDR was re-optimized to enable wider bending ranges of the continuum joints (>90 deg) to generate an enlarged workspace, taking into consideration several possible structural interferences. Furthermore, a kinetostatic model is derived based on the Cosserat rod theory to reduce the positioning errors caused by the external loads. The experimental result showed that the workspace is enlarged to approximately 9.47 x 10(7) mm(3) compared with the volume of 6.57 x 10(7) mm(3) of the initial version. Within this enlarged workspace, the average positioning error with a 1000-g load was reduced to 1.93 mm, compared with 4.43 mm obtained by the previous constant curvature assumption.

FABRIKc Delta: Extending the FABRIKc Algorithm to Solve the Forward Kinematics of a Continuum Delta Robot

FABRIKc: an Efficient Iterative Inverse Kinematics Solver for Continuum Robots

FABRIKx: Tackling the Inverse Kinematics Problem of Continuum Robots with Variable Curvature

An Efficient Inverse Kinematics Algorithm For Continuum Robot With A Translational Base

Continuum Delta Robot: a Novel Translational Parallel Robot with Continuum Joints

CRRIK: A Fast Heuristic Algorithm for the Inverse Kinematics of Continuum Robot

A Combined Inverse Kinematics Algorithm Using FABRIK with Optimization

Kinetostatic Modeling of Continuum Delta Robot with Variable Curvature Continuum Joints

The Forward and Inverse Kinematics of a Delta Robot

Efficient and Scalable Inverse Kinematics for Continuum Robots

Full Forward Kinematics of Lower-Mobility Planar Parallel Continuum Robots

FABRIKv: A Fast, Iterative Inverse Kinematics Solver for Surgical Continuum Robot with Variable Curvature Model

Advanced Parallel Robot with Extended RSUR Kinematic for a Circulating Working Principle.

Design and Kinematics of a Novel Continuum Robot Connected by Unique Offset Cross Revolute Joints

Dynamic Modeling and Control Simulation of a Modified Delta Manipulator.

CIDGIKc: Distance-Geometric Inverse Kinematics for Continuum Robots

A hybrid method using FABRIK and custom ANN in solving inverse kinematic for generic serial robot manipulator

Novel and Robust Forward Kinematic Algorithm for Real-Time Control of General Six-Degree-of-Freedom Parallel Robot for Tele-Manipulation and Tele-Navigation

Planning and Inverse Kinematics of Hyper-Redundant Manipulators with VO-FABRIK

CafkNet: GNN-Empowered Forward Kinematic Modeling for Cable-Driven Parallel Robots

Data-Driven Inverse Kinematics Approximation of a Delta Robot with Stepper Motors