Molten salt-shielded preparation of the ultrathin nanosheets of Ti3C2Cl2 @TiO2 coupled with Fe3O4@C-C3N4 for assessing photocatalytic activity
Mojtaba Rostami,Alireza Badiei
DOI: https://doi.org/10.1016/j.ceramint.2024.01.275
IF: 5.532
2024-02-01
Ceramics International
Abstract:Traditional methods for producing MXene have been limited by their use of hazardous conditions, high expenses, and difficulties scaling up production. Given these limitations, we propose an affordable, swift, eco-friendly, and low-temperature (1000 °C) technique for synthesizing the Ti3AlC2 MAX phase in an air atmosphere, employing a molten salt-shielded synthesis (MS3) approach. TiO2-Ti3C2Cl2 MXenes were subsequently created through an in situ etching process using the CuCl2 Lewis acid salts method at a temperature of 750 °C. The primary obstacles in semiconductor photocatalysis revolve around three key issues: the ability to separate the photocatalyst using magnets from wastewater, limited absorption of visible (Vis) light, and the efficient separation and transfer of charge carriers on the photocatalyst's surface. To overcome these challenges, a quaternary type-II heterojunction nanocomposite photocatalyst denoted as TiO2-Ti3C2Cl2-C3N4-Fe3O4@C (TTCF), was synthesized using a pyrolysis process. Binary C3N4-Fe3O4@C (CF), ternary TiO2-Ti3C2Cl2-C3N4 (TTC), and quaternary TTCF nanocomposites all displayed a red-shift towards longer wavelengths when compared to pure g-C3N4. This shift is attributed to the formation of heterojunction structures between g- C3N4 and either TiO2- Ti3C2Cl2 or Fe3O4@C. It addresses the issues of magnetic separability, enhanced Vis -light absorption, and improved charge carrier separation and transfer in semiconductor photocatalysis processes. The optimal performance, yielding removal rates of 99.94 %, 94.75 %, and 88.94 %, was attained with the quaternary TTCF nanocomposite under the conditions of pH 5, utilizing a 100 ppm nanophotocatalyst dosage, a 10 ppm concentration each of Rhodamine B (Rh B), Sulfamethoxazole (SMX), and Acetaminophen (ACT), and a reaction time of 30 min at room temperature. Furthermore, the TTCF nanocomposite photocatalyst demonstrated excellent recyclability, maintaining its effectiveness over nine cycles.
materials science, ceramics