Abstract:As a consequence of limb loss, unilateral lower limb amputees (LLAs) exert additional flexion torque in the intact limb during postural balance, leading to other secondary complications. A prosthetic device with torque delivery is required to avoid such complications. However, estimating desired torque is an acknowledged challenge in this domain. Motivated by the above, this paper focuses on estimating the corrective torque required from an assistive device to balance the individual while performing weight-shifting exercises. Further, a healthy individual’s inverted pendulum (IP) model is explored to model LLA’s dynamics during weight-shifting. The model and the control strategy are validated using forward and backward body lean angles recorded from healthy and LLA individuals. Finally, a robust Proportional Integral Derivative controller is designed to estimate the corrective torque for maintaining the postural balance during weight-shifting. Along with the IP dynamics, a suitable control law based on Coefficient Diagram Method achieves the experimentally recorded body lean angle. The proposed control scheme is validated through simulation studies to evaluate the tracking performance in two different biomechanically relevant IP postural models. The findings assist in determining the external torque required to maintain the postural balance during gait initiation and compensatory measures for pathologically reduced torque. Note to Practitioners—Gait initiation is a transition between vertical posture and gait. Since vertical stance is inherently unstable, a postural adjustment occurs before gait initiates, propelling the center of mass forward and towards the first stance leg. The absence of flexor torque in the amputated limb causes a loss of postural stability during weight shifting activities. In the case of powered exoskeletons and prosthetic devices, a prior estimation of corrective torque through a computational approach helps to select a suitable actuator that provides an appropriate joint torque while maintaining the postural balance. As a result, an efficient computational model of gait initiation that accounts for neuromuscular system components before designing assistive devices is necessary. The controllers further provide corrective action to the assistive device to obtain robust and optimal coordination between the prosthetic element and gait. Therefore, this study demonstrates the significance of neuromuscular controller and assists in determining how much corrective torque from an external device is required to maintain postural stability and adaptability during weight shifting exercises. The effectiveness of the neural controller is also tested for real-time data to compensate for the effect of external disturbance and noise, thereby achieving a proper and controlled degree of movement in amputee users. These findings could provide one of the fundamental aspects of gait initiation model paradigms of compensatory measures for pathologically diminished torque and contribute to developing low-cost prosthetic solutions for the benefit of the rehabilitation society in developing countries.

Indirect Measurement of Upper Limb Load for Users of Four-Wheeled Mobility Aids Based on Torque Sensors

Differential Soft Sensor-Based Measurement of Interactive Force and Assistive Torque for a Robotic Hip Exoskeleton

Handrim Reaction Force and Moment Assessment Using a Minimal IMU Configuration and Non-Linear Modeling Approach during Manual Wheelchair Propulsion

Development and Evaluation of a Wearable Upper Limb Assistive Device with a Remote Center of Motion Mechanism

Improving Walking Assist Hip Exoskeleton Torque Efficiency with Decoupling Mechanism

Development of Assistance Level Adjustment Function for Variable Load on a Forearm-Supported Robotic Walker

Defective gap junctional intercellular communication in lung cancer: loss of an important mediator of tissue homeostasis and phenotypic regulation.

Walking and scuba diving assisted amphibious exoskeleton robots: the designing of power assist control and myoelectricity based wearers' fatigue evaluation

Estimation of joint torque in dynamic activities using wearable A-mode ultrasound

Real-Life Wheelchair Mobility Metrics from IMUs

A Wearable Flexible Exoskeleton for Upper Limb Assistance

Wearable-Based Kinematic Analysis of Upper-Limb Movements During Daily Activities Could Provide Insights into Stroke Survivors' Motor Ability

Motor Function Evaluation of Hemiplegic Upper-Extremities Using Data Fusion from Wearable Inertial and Surface EMG Sensors

Enable Fully Customized Assistance: A Novel IMU-based Motor Intent Decoding Scheme

Development of a Capacitive Force/Torque Sensor for Lower Limb Rehabilitation Robots for Spasm Detection

Simulating Ankle Torque during Walking Using a new Bioinspired Muscle Model with Application for Controlling a Powered Exoskeleton

Neuromechanical Model-Based Corrective Torque Estimation During Weight Shifting in Lower Limb Amputees

Knee Joint Torque Estimation in Femoral Prosthesis Users Using MMG and Low-Frequency Acceleration

Antimuscle factor and antinuclear factor in patients with myasthenia gravis. 1. Heavy chain determinants.

Effect of sensor number and location on accelerometry-based vertical ground reaction force estimation during walking