Location and Quantitative Analysis of OH in Coesite
M. Koch-Müller,Y. Fei,E. Hauri,Z. Liu
DOI: https://doi.org/10.1007/s002690100195
IF: 1.748
2001-01-01
Physics and Chemistry of Minerals
Abstract:The incorporation of hydrogen (deuterium) into the coesite structure was investigated at pressures from 3.1 to 7.5 GPa and temperatures of 700, 800, and 1100 °C. Hydrogen could only be incorporated into the coesite structure at pressures greater 5.0 GPa and 1100 °C . No correlation between the concentration of trace elements such as Al and B and the hydrogen content was observed based on ion probe analysis (1335 ± 16 H ppm and 17 ± 1 Al ppm at 7.5 GPa, 1100 °C). The FTIR spectra show three relatively intense bands at 3575, 3516, and 3459 cm −1 (ν 1 to ν 3 , respectively) and two very weak bands at 3296 and 3210 cm −1 (ν 4 and ν 5 , respectively). The band at 3516 cm −1 is strongly asymmetric and can be resolved into two bands, 3528 (ν 2a ) and 3508 (ν 2b ) cm −1 , with nearly identical areas. Polarized infrared absorption spectra of coesite single-crystal slabs, cut parallel to (0 1 0) and (1 0 0), were collected to locate the OH dipoles in the structure and to calibrate the IR spectroscopy for quantitative analysis of OH in coesite (ɛ i ,tot =190 000 ± 30 000 l mol −1 H2O cm −2 ). The polarized spectra revealed a strong pleochroism of the OH bands. High-pressure FTIR spectra at pressures up to 8 GPa were performed in a diamond-anvil cell to gain further insight into incorporation mechanism of OH in coesite. The peak positions of the ν 1 , ν 2 , and ν 3 bands decrease linearly with pressure. The mode Grüneisen parameters for ν 1 , ν 2 , and ν 3 are −0.074, −0.144 and −0.398, respectively. There is a linear increase of the pressure derivatives with band position which follows the trend proposed by Hofmeister et al. (1999). The full widths at half maximum (FWHM) of the ν 1 , ν 2 , and ν 3 bands increase from 35, 21, and 28 cm −1 in the spectra at ambient conditions to 71, 68, and 105 in the 8 GPa spectra, respectively. On the basis of these results, a model for the incorporation of hydrogen in coesite was developed: the OH defects are introduced into the structure by the substitution Si 4+(Si2) +4O 2− = [4] □ (Si2) + 4OH − , which gives rise to four vibrations, ν 1 , ν 2a , ν 2b , and ν 3 . Because the OH(D)-bearing samples do contain traces of Al and B, the bands ν 4 and ν 5 may be coupled to Al and/or B substitution.