Abstract:Orthopaedic Journal of Sports Medicine, Volume 12, Issue 10, October 2024. Background:Posterior medial meniscus root (PMMR) tears (PMMRTs) can be repaired using various techniques to promote healing. However, the biomechanical properties of suture-relay all-suture anchor (ASA) versus conventional suture anchor (CSA) and loop-locking transtibial pullout (TTP) have not been well established.Purpose:To compare the biomechanical properties of PMMR repairs using suture-relay ASA, CSA, and loop-locking TTP.Study Design:Controlled laboratory study.Methods:A total of 33 fresh-frozen porcine knee joints with intact medial menisci were randomly divided into 3 groups, with 11 specimens in each group: ASA, CSA, and TTP. The study involved cyclic loading, with displacement measurements taken after 100, 500, and 1000 cycles. Subsequently, the specimens were loaded until clinical failure (defined as 3-mm displacement) and then to ultimate failure of the construct, with data recorded for displacement after cyclic loading, load to 3-mm displacement, and ultimate load to failure.Results:After 1000 cyclic loadings, the suture-relay ASA group showed considerably less displacement than the loop-locking TTP group (1.8 ± 0.7 mm vs 2.9 ± 0.3 mm; P .05). The mean loads to clinical failure were significantly greater in the suture-relay ASA and CSA groups (61.3 ± 6.5 and 57.5 ± 9.7 N, respectively) than in the loop-locking TTP group (38.3 ± 9.4 N; P < .05). The ultimate load to failure was significantly greater in the suture-relay ASA group than in the loop-locking TTP group (153 ± 55.1 N vs 102 ± 12.9 N; P < .05). All specimens in the loop-locking TTP group failed by suture elongation mode, whereas only 2 specimens (18%) in the suture-relay ASA group and 5 specimens (45%) in the CSA group failed by suture elongation. Nine specimens (82%) in the suture-relay ASA group and 6 specimens (55%) in the CSA group failed due to suture cutout through the meniscal tissue.Conclusion:The biomechanical properties after PMMR repair did not statistically differ between the suture-relay ASA and CSA groups. The suture-relay ASA technique had a higher load to failure than the loop-locking TTP technique.Clinical Relevance:The suture-relay ASA technique is a promising option for the repair of PMMRTs; its repairing strength is also comparable to that of the CSA technique. Notably, the suture-relay ASA technique can be utilized without establishing a posteromedial portal, resulting in decreased procedure time and mitigating challenges associated with working from the posterior aspect of the knee.

Knotless Suture Anchors Display Favorable Elongation but an Inferior Ultimate Failure Load Versus Titanium Suture Anchors and All-Suture Anchors: A Biomechanical Comparison in a Porcine Model

Knotless anchors offer better prevention of meniscal excursion than knotted anchors: An experimental study of the bovine knee

Biomechanical Comparison of Coracoclavicular Fixation Using Metallic Versus All-Suture Anchors

Self-Tensioning Feature of Knotless Suture Anchor Provides Reproducible Knotless Fixation Independent of Initial Tension

Anatomic Knot Suture Anchor Versus Knotless Suture Anchor Technique for Anterior Talofibular Ligament Repair: A Biomechanical Comparison

A Symmetric Anchor Designed Barbed Suture Versus Conventional Interrupted Sutures In Total Knee Arthroplasty: A Multicenter, Randomized Controlled Trial

Biomechanical Comparison of Suture-Relay All-Suture Anchors and Conventional Suture Anchors for Posterior Medial Meniscus Root Repair in Porcine Models

An All-Suture Anchor Offers Equivalent Clinical Performance to an Established Solid Suture Anchor in the Arthroscopic Repair of Rotator Cuff Tears: A Prospective, Randomized, Multi-Center Trial With 12-Month Follow Up

Strength of suture anchor versus transosseous tunnel in anatomic reconstruction of the ankle lateral ligaments: a biomechanical study.

Comparing the biomechanical properties of conventional suture and all-suture anchors using patient-specific and realistic osteoporotic and non-osteoporotic phantom using 3D printing

An All-Suture Anchor Offers Equivalent Clinical Performance to an Established Solid Suture Anchor in the Arthroscopic Repair of Rotator Cuff Tears: A Prospective, Randomized, Multicenter Trial with 12-Month Follow-Up

All-Suture Anchor vs. Knotless Suture Anchor for the Treatment of Anterior Shoulder Instability—A Prospective Cohort Study

Comparison of Knotless Versus Knot-Tying Suture Anchors for Arthroscopic Repair of Hip Labral Tears

Effect of cyclic loading on the ultimate tensile strength of small metallic suture anchors used for attaching artificial tendons in rabbits

Biomechanical properties of suprapectoral biceps tenodesis with double-anchor knotless luggage tag sutures vs. subpectoral biceps tenodesis with single-anchor whipstitch suture using all-suture anchors

Superior load-to-failure in an all-suture anchor system for all-inside meniscal repair compared to a PEEK-cage anchor system in an experimental cadaveric test setting

Biomechanical analysis of bioabsorbable suture anchors for rotator cuff repair using osteoporotic and normal bone models

All-Suture and Solid Medial Row Anchors Produce Similar Clinical Outcomes for Double Row Suture Bridge Rotator Cuff Repair (227)

Stabilization and Gap Formation of Adjustable Versus Fixed Primary ACL Repair With Internal Brace: An in Vitro Full-Construct Biomechanical Cadaveric Study

Biomechanical Analysis Evaluating Meniscal Extrusion After Knotless Suture Anchor Fixation for Segmental Medial Meniscal Allograft Transplantation

Biomechanical Characteristics of All-Suture Meniscal Repair Devices Compared With PEEK-Anchored Devices and Inside-Out Suture for Meniscal Repair: A Porcine Study