Abstract:Guide vane submersible centrifugal pumps are a kind of submersible pump, and the fluid inside the pump is often mixed with gravel and other impurities during operation, affecting the pump's operating efficiency and life expectancy. However, past studies on solid–liquid two-phase flow (STF) and wear characteristics in guided vane centrifugal pumps have been limited to the particle trajectory and wear region distribution. These studies have lacked research on the effect of particles on the fluid flow and the specific amount of wear on the overflow components. Additionally, most of them have used the DPM discrete-phase model, which does not consider the particle–particle and particle–wall interactions. This paper is based on the CFD–DEM method, combined with the Archard wear model. A solid–liquid two-phase flow simulation is carried out for pumps with different particle sizes and particle shapes to analyze the particle movement inside the pump, the wear distribution and average wear amount of the overflow components, and the effect of particles on the turbulent kinetic energy of the fluid. The results show that the particles mainly collide with the leading and trailing edges of the impeller blades and the leading edge of the guide vane blades and form a buildup at the trailing edge of the concave surface of the guide vane blades, resulting in the wear being mainly distributed in these regions. With an increase in particle size and a decrease in sphericity, the average wear on the overflow components increases. The change of particle size directly affects the resistance of the fluid and the structure of the flow field, which has a large impact on the fluid flow pattern and generates large turbulent kinetic energy fluctuations. The shape of the particles only changes the structure of the local flow field, which has a small impact on the fluid flow pattern.

Numerical Simulation of Centrifugal Pump Impeller Erosion Caused by Particles in Lead–bismuth Alloy

Lubrication Performance Analysis of Lead-Bismuth Internal-Feedback Bearings in the Nuclear Main Pump System

Effects of Particle Erosion on the Submersible Pump in an Ultra-High Voltage Transformer

Experimental Study on the Influence of Particle Diameter, Mass Concentration, and Impeller Material on the Wear Performance of Solid–Liquid Two-Phase Centrifugal Pump Blade

Numerical Prediction of the Effect of Typical Particle Properties on a Centrifugal Pump

Simulation study on creep deformation of the impeller in lead-bismuth eutectic environment through fluid-solid coupling method

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Study on the erosion characteristics of mixed-flow pumps under forced action of solid particles

Erosion Wear on Impeller of Double-Suction Centrifugal Pump Due to Sediment Flow

Numerical Simulation of Erosion and Particle Motion Trajectory in Centrifugal Pump

Numerical Simulation Prediction of Erosion Characteristics in a Double-Suction Centrifugal Pump

Prediction of Abrasive and Impact Wear Due to Multi-Shaped Particles in a Centrifugal Pump via CFD-DEM Coupling Method

Effect of particle mass concentration on erosion characteristics of self-priming pump

Study on Wear Characteristics of a Guide Vane Centrifugal Pump Based on CFD–DEM

Centrifugal pump wear for solid–liquid two-phase flows based on computational fluid dynamics–discrete element method coupling

Investigation on wear induced by solid-liquid two-phase flow in a centrifugal pump based on EDEM-Fluent coupling method

Experimental Research on the Movement Rule of Solid Particles in Centrifugal Pump

Numerical Prediction of Erosion Based on the Solid-Liquid Two-Phase Flow in a Double-Suction Centrifugal Pump

Numerical study on flow and wear characteristics of dense fine particle solid–liquid two-phase flow in centrifugal pump

Numerical Investigation of the Erosion Behavior in Blades of Tidal Current Turbine

Slurry Flow And Erosion Prediction In A Centrifugal Pump After Long-Term Operation