Abstract:Emissions tests were conducted on two medium heavy-duty diesel trucks equipped with a particulate filter (DPF), with one vehicle using a NOx absorber and the other a selective catalytic reduction (SCR) system for control of nitrogen oxides (NOx). Both vehicles were tested with two different fuels (ultra-low-sulfur diesel [ULSD] and biodiesel [B20]) and ambient temperatures (70ºF and 20ºF), while the truck with the NOx absorber was also operated at two loads (a heavy weight and a light weight). The test procedure included three driving cycles, a cold start with low transients (CSLT), the federal heavy-duty urban dynamometer driving schedule (UDDS), and a warm start with low transients (WSLT). Particulate matter (PM) emissions were measured second-by-second using an Aethalometer for black carbon (BC) concentrations and an engine exhaust particle sizer (EEPS) for particle count measurements between 5.6 and 560 nm. The DPF/NOx absorber vehicle experienced increased BC and particle number concentrations during cold starts under cold ambient conditions, with concentrations two to three times higher than under warm starts at higher ambient temperatures. The average particle count for the UDDS showed an opposite trend, with an approximately 27% decrease when ambient temperatures decreased from 70ºF to 20ºF. This vehicle experienced decreased emissions when going from ULSD to B20. The DPF/SCR vehicle tested had much lower emissions, with many of the BC and particle number measurements below detectable limits. However, both vehicles did experience elevated emissions caused by DPF regeneration. All regeneration events occurred during the UDDS cycle. Slight increases in emissions were measured during the WSLT cycles after the regeneration. However, the day after a regeneration occurred, both vehicles showed significant increases in particle number and BC for the CSLT drive cycle, with increases from 93 to 1380% for PM number emissions compared with tests following a day with no regeneration. Implications: The use of diesel particulate filters (DPFs) on trucks is becoming more common throughout the world. Understanding how DPFs affect air pollution emissions under varying operating conditions will be critical in implementing effective air quality standards. This study evaluated particulate matter (PM) and black carbon (BC) emissions with two DPF-equipped heavy-duty diesel trucks operating on conventional fuel and a biodiesel fuel blend at varying ambient temperatures, loads, and drive cycles.

Enhanced Diesel Emissions at Low Ambient Temperature: Hazardous Materials in Fine Particles.

Particulate matter emissions from light-duty gasoline vehicles under different ambient temperatures: Physical properties and chemical compositions

Low-Condensation Diesel Use Contributes to Winter Haze in Cold Regions of China

IMPACTS OF AMBIENT TEMPERATURE AND PRESSURE ON PM2.5 EMISSION PROFILES OF LIGHT-DUTY DIESEL VEHICLES

Temperature effects on particulate emissions from DPF-equipped diesel trucks operating on conventional and biodiesel fuels

Response to the Letter to Editor on "global Performance and Trends of Research on Per- and Polyfluoroalkyl Substances (pfass) Between 2001 and 2018 Using Bibliometric Analysis" from Fujii Et Al. (2022).

Particle number emissions from fully warmed gasoline vehicles at various ambient temperatures

Characterizing Particulate Polycyclic Aromatic Hydrocarbon Emissions from Diesel Vehicles Using a Portable Emissions Measurement System

Emission Measurements on a Large Sample of Heavy-Duty Diesel Trucks in China by Using Mobile Plume Chasing

Sub-23 nm Particle Emissions from China-6 GDI Vehicle: Impacts of Drive Cycle and Ambient Temperature

Chemical Characterization of PM2.5 Emitted from On-Road Heavy-Duty Diesel Trucks in China

Chemical and toxicological characterization of particulate emissions from diesel vehicles

Technical note: Emission factors, chemical composition, and morphology of particles emitted from Euro 5 diesel and gasoline light-duty vehicles during transient cycles

Impact of cold temperature on Euro 6 passenger car emissions

Exploring ultrafine particle emission characteristics from in-use light-duty diesel trucks in China using a portable measurement system

Research on Particle Emissions of Light-duty Hybrid Electric Vehicles in Real Driving

PM2.5 emissions from different types of heavy-duty truck: a case study and meta-analysis of the Beijing-Tianjin-Hebei region

Morphology, Composition, and Mixing State of Individual Aerosol Particles in Northeast China During Wintertime

Characterization of the chemical composition of PM2.5 emitted from on-road China III and China IV diesel trucks in Beijing, China

Chemical Characterization and Toxicity Assessment of Fine Particulate Matters Emitted from the Combustion of Petrol and Diesel Fuels.

Emissions of Intermediate- and Semi-Volatile Organic Compounds (i/svocs) from Different Cumulative Mileage Diesel Vehicles under Various Ambient Temperatures