Abstract:This study was aimed to prepare the whey protein isolate(WPI) – sodium tripolyphosphate(STPP) aggregates using heating at higher pH value and evaluate their characteristics. The results of single-factor experiment showed that the increase of viscosity of polymers was different from the increasing of WPI concentration, temperature, p H value, STPP content and aggregation time. The models were obtained by using a Box-Behnken optimization experiment design with the 4 factors(temperature, p H value, STPP content and aggregation time) based on the results of single-factor experiments. The results of Box-Behnken optimization experiment showed that the order of the effect of the 4 factors on viscosity was as follows: temperature > STPP content > p H value > aggregation time. The optimized condition determined was that 10%(w/w) WPI, 0.09%(w/w) STPP at 90°C for 42 min with p H value of 8.40, and the actual viscosity was 5083 mP a·s. The prepared WPI-STPP thermal aggregates were the thick sample with a semi flow state, and the regression model was fitted well. Determination of properties and structural analysis of WPI, WPI-STPP thermal aggregates and WPI aggregates showed the water holding capacity, surface hydrophobicity and rheological characteristics of WPI-STPP thermal aggregates were improved compared with WPI and WPI aggregates. For WPI aggregates, water holding capacity increased from 4.83 to 5.20 g per gram protein(P<0.05). However, the solubility of WPI-STPP thermal aggregates decreased from 88.5% to 34.50%, which was lower than that of WPI. Heat treatment and STPP significantly affected the surface hydrophobicity of the soluble aggregates. WPI-STPP thermal aggregates could form good cold-induced gels, which could widen its application in foods of gel type. When STPP was added, the average particle size of whey protein thermally polymerized increased from 31.39±1.81 μm for WPI to 292.09±2.17 μm for WPI-STPP thermal aggregates. The difference between strong and weak soluble gels could be assessed by the oscillatory dynamic experiments using parallel-plate geometries. Rotational rheometer showed that the rheological characteristics of WPI-STPP thermal aggregates were improved. The rheological characteristics were determined from storage and loss moduli as the functions of time and frequency. WPI-STPP thermal aggregates had higher storage modulus values. The results showed that the increasing of particles played a significant role in the water holding capacity and rheological properties of these dispersions. The microscopic structure analysis of WPI-STPP thermal aggregates showed that they denatured fully, and the larger irregular fractal aggregates of WPI-STPP thermal aggregates could be most useful to increase the viscosity. Transmission electron microscopy showed that heat-induced WPI-Na Cl soluble gels had a dense structure and a higher number of cross-links. The utilization of WPI-STPP thermal aggregates is very attractive due to the low-complexity processing conditions needed, lower production cost and higher nutritive value. The production cost of yogurt is less than yogurt with pectin according to the optimal technological condition of the experiment. The application of this technology proposed in this paper will bring great economic benefits for the yogurt processing industry.

The Effect of Different Edible Fungal Polysaccharides on the Stability of Whey Protein Isolate Solution Near Isoelectric Point

The Effect of Whey Protein Isolate Hydrolysate on Digestive Properties of Phytosterol

Molecular Properties of Flammulina velutipes Polysaccharide–Whey Protein Isolate (WPI) Complexes via Noncovalent Interactions

Effect of Different Anionic Polysaccharides on Whey Protein's S/O/W Bilayer Emulsions Containing EGCG: Molecular Interaction and Stability under Various Environmental Stresses

Mechanistic insights into the interaction of Lycium barbarum polysaccharide with whey protein isolate: Functional and structural characterization

The effect of sweet tea polysaccharide on the physicochemical and structural properties of whey protein isolate gels

Effects of ethanol pre-treated whey protein isolates on the physical stability and protein-lipid co-oxidation in oil-in-water emulsions

Interaction and Phase Behavior of Whey Protein and Propylene Glycol Alginate Complex Condensates

Structural and functional properties of whey protein isolate-inulin conjugates prepared with ultrasound or wet heating method

Comparative Studies on the Stabilization of Pea Protein Dispersions by Using Various Polysaccharides

Effects of Covalent Binding of Different Polyphenols on Structure, Rheology and Functional Properties of Whey Protein Isolate

Characterization of Coacervation Behavior Between Whey Protein Isolate and Propylene Glycol Alginate: A Morphology, Spectroscopy, and Thermodynamics Study

The influence of the interaction between whey protein and erythritol on protein conformation, interfacial properties and stability

Impacts of Cold-Extrusion Whey Protein Isolate Synergized with Inulin on Physicochemical Characteristics of Fermented Milk

Effects of Polyols on the Stability of Whey Proteins in Intermediate-Moisture Food Model Systems.

Effect of interactions between glycosylated protein and tannic acid on the physicochemical stability of Pickering emulsions

The Stability of Ginseng Whey Protein Polypeptide Beverage

The Effect of Whey Protein Isolate-Dextran Conjugates on the Freeze-Thaw Stability of Oil-in-Water Emulsions

Preparation and characters of whey protein isolate-sodium tripolyphosphate aggregates by heating

Effect of Enzymatic Hydrolysis and Ultrasound Pretreatment on Allergenicity, Functional Properties and Bioactivity of Whey Protein Isolates

A novel improvement in whey protein isolate emulsion stability: Generation of an enzymatically cross-linked beet pectin layer using horseradish peroxidase