Abstract:To investigate the effect of alkali (K and Na) and alkaline earth (Ca and Mg) metal poisoning and hydrothermal aging on Cu-SAPO-34 catalyst; a series of samples containing various metals (Mg, Ca, Na and K) loadings were prepared by an impregnation method, and the changes of catalytic properties were evaluated before and after hydrothermal aging by various characterization techniques. The results indicated that the surface area, the isolated Cu2+ ions and the acidity of Cu-SAPO-34 catalyst were well-maintained after low alkali and alkaline earth metal contents (0.50 mmol/g(cat)) incorporation. The results showed that at high content (1.50 mmol/g(cat)), the great decrease of SCR performance was explained by the destruction of the zeolite structure, the decrease in acidity and the transformation of Cu2+ ions to CuO detected by XRD, NH3-TPD and H-2-TPR techniques, respectively. The NH3-SCR performance of the fresh and aged samples was similar after high-temperature (650 degrees C) hydrothermal aging treatment for 12 h. A slight increase of activity was observed when the samples were hydrothermal aging at 700 and 750 degrees C for 12 h due to the change of Cu species distribution. The NH3-TPD results show that the acidity was not affected by hydrothermal aging treatment. During hydrothermal aging process, CuO species first precipitated on the external surface and then dispersed as isolated Cu2+ ions over Cu-SAPO-34. The Cu-SAPO-34 could withstand the co-effect of chemical poisoning (K, Na and Ca) and hydrothermal aging at 750 degrees C at the same times. In summary, our results indicated that the pore blocking, disruption of the zeolite framework, reduction of acid sites and active sites were the reasons for the chemical the deactivation of Cu-SAPO-34 catalyst after the introduction of metals.

Improvement of Cu-SAPO-34 Hydrothermal Stability by Tuning P/Al Ratio for Selective Catalytic Reduction of NO by NH3.

Boosting the Catalytic Performance of Cu-SAPO-34 in NOx Removal Via Hydrothermal Treatment.

Optimization of Hybrid Crystal with SAPO-5/34 on Hydrothermal Stability for deNOx Reaction by NH3

Investigation of low-temperature hydrothermal stability of Cu-SAPO-34 for selective catalytic reduction of NOx with NH3

Boosting the catalytic performance of Cu-SAPO-34 in NO removal via hydrothermal treatment

Grain Size Effect on the High-Temperature Hydrothermal Stability of Cu/SAPO-34 Catalysts for NH3-SCR

Optimization of isolated copper species on the NH 3 -SCR performance over Cu/SSZ-39 modified by ammonia water

Optimization of Isolated Copper Species on the NH3-SCR Performance over Cu/SSZ-39 Modified by Ammonia Water

Enhanced hydrothermal stability of Cu-SSZ-13 by compositing with Cu-SAPO-34 in selective catalytic reduction of nitrogen oxides with ammonia

Improving the Low-Temperature Hydrothermal Stability of Cu-SAPO-34 by the Addition of Ag for Ammonia Selective Catalytic Reduction of NO X

A controllable zeolite framework stability of Cu/SAPO-34 via adjusting the copper coordination environment for NH 3 -SCR under hydrothermal condition

Enhanced performance for selective catalytic reduction of NOx with NH3 over nanosized Cu/SAPO‐34 catalysts

Direct Synthesis of Submicron Cu-SAPO-34 As Highly Efficient and Robust Catalyst for Selective Catalytic Reduction of NO by NH3

Improved Hydrothermal Stability of Cu-Sapo-18 by Sm Modification in the Selective Catalytic Reduction of Nox with Nh3

One-pot Synthesis of High Performance Cu-SAPO-18 Catalyst for NO Reduction by NH3-SCR: Influence of Silicon Content on the Catalytic Properties of Cu-SAPO-18

Spotlight on Cu/SAPO-34 with high hydrothermal stability induced by a small amount of SSZ-39

Neodymium Promotion on the Low-Temperature Hydrothermal Stability of a Cu/SAPO-34 NH 3 -SCR Monolith Catalyst

Atomic layer deposition of silica to improve the high-temperature hydrothermal stability of Cu-SSZ-13 for NH3 SCR of NOx

The influence of chemical poisoning, hydrothermal aging and their co-effects on Cu-SAPO-34 catalyst for NOx reduction by NH3-SCR

Promotional Effect of Ce on Cu-SAPO-34 Monolith Catalyst for Selective Catalytic Reduction of NOx with Ammonia

Effective reduction of nitric oxide over a core–shell Cu-SAPO-34@Fe-MOR zeolite catalyst