Abstract:Quartz lamp heaters and hypersonic wind tunnel are currently applied in thermal assessment of heat resistant materials and surface of aircraft. However, it is difficult to achieve precise heat flux distribution by quartz lamp heaters, while enormous energy is required by a large scale hypersonic wind tunnel. Electron beam can be focused into a beam spot of millimeter scale by an electromagnetic lens and electron-magnetically deflected to achieve a rapid scanning over a workpiece. Moreover, it is of high energy utilization efficiency when applying an electron beam to heat a metal workpiece. Therefore, we propose to apply an electron beam with a variable speed to establish a novel method to realize various non-uniform heat flux boundary conditions. Besides, an electron beam thermal assessment equipment is devised. To analyze the feasibility of this method, an approach to calculate the heat flux distribution formed by an electron beam with variable-speed scanning is constructed with beam power, diameter of the beam spot and dwell duration of the electron beam at various locations as the key parameters. To realize a desired non-uniform heat flux distribution of the maximum gradient of 1.1 MW/m3, a variable-speed scanning strategy is constructed on basis of the conservation of energy. Compared with the desired heat flux, the maximum deviation of the scanned heat flux is 4.5% and the deviation in the main thermal assessment area is less than 3%. To verify the method, taking the time-average scanned heat flux as the boundary condition, a heat transfer model is constructed and temperature results are calculated. The experiment of variable-speed scanning of an electron beam according to the scanning strategy has been carried out. The measured temperatures are in good agreement with the predicted results at various locations. Temperature fluctuation during the scanning process is analyzed, and it is found to be proportional to the scanned heat flux divided by volumetric heat capacity, which is applicable for different materials up to 3.35 MW/m2. This study provides a novel and effective method for precise realization of various non-uniform heat flux boundary conditions.

Fraction Frequency and Random Scanning Mode for Electron Beam Thermal Assessment

High-precision Reconstruction of the Heat Flux Field by a Scanning Electron Beam for Thermal Assessment of a Hypersonic Vehicle

Analysis of Electromagnetic Scattering Characteristics for a HTV-2 Type Flight Vehicle Ablation Flows

A novel method to realize a non-uniform heat flux distribution through the variable-speed scanning of an electron beam

Study on the Variation of Gas Radiation Characteristics of Hypersonic Reentry Vehicles

Analysis of Weakly Ionized Ablation Plasma Flows for a Hypersonic Vehicle

High-precision Reconstruction of a Heat Flux Boundary Via a Programmable Scanning Electron Beam Controlled by the Voltage Waveform Design Method

Flow Field Radiation Characteristics Extraction and Analysis of the Re-Entry Orbital Test Vehicle

Modeling and Simulation of Radiation from Electronic Transitions in Hypersonic Atmospheric Reentry Flow

Open-loop Temperature Rise History Control Method with Scanning Electron Beam As a Programmable Heat Source

Numerical study on the non-equilibrium characteristics of high-speed atmospheric re-entry flow and radiation of aircraft based on fully coupled model

Theoretical Simulation of Thermal Behavior in Transient Heat Loads Testing of Plasma-Facing Materials

A High Temporal-Spatial Resolution Temperature Sensor for Simultaneous Measurement of Anisotropic Heat Flow

Heat Transfer Simulation and Analysis of Electron Collector Based on Real-time Uniformity Detection Device of Irradiation Accelerator

Analysis of Electromagnetic Scattering by Hypersonic Objects in Near Space

Numerical Simulation of Spectral Radiation for Hypersonic Vehicles

High temperature heat flux sensor with ITO/In2O3 thermopile for extreme environment sensing

A Rapid Reconstruction Strategy of Full-Domain Temperature Field Based on Discrete Measurement Points for Electronics Thermal Management

Analysis of Cold/Hot Spot Effect in Flight Test Heat Flux Measurement

Assessing skin thermal injury risk in exposure tests of heating until flight

Studies on the propagation properties of THz wave in inhomogeneous dusty plasma sheath considering scattering process