Experiment and Numerical Simulation of Water Plugging Law of Permeable Polymer in the Water-Rich Sand Layer
FANG HongYuan,LIU Kang,DU XueMing,WANG FuMing
DOI: https://doi.org/10.1360/sst-2021-0461
2022-01-01
Scientia Sinica Technologica
Abstract:When constructing a tunnel through a water-rich sand layer, permeation grouting is one of the important methods for preventing seepage and plugging water. Unlike typical chemical slurries, permeable polymers have the characteristics of two-component reaction and rapid consolidation throughout the slurry diffusion process, making them suited for grouting and plugging water in water-rich sand layers. However, due to the characteristics of rapid consolidation in the diffusion process, the diffusion law in a water-rich sand layer is more complex. To study the water plugging effect of this permeable polymer in the water-rich sand layer, a set of visualized permeable grouting model test devices for the water-rich sand layer was created, which has the functions of observing the slurry diffusion distance, monitoring the pore water pressure change before and after grouting, and measuring the water plugging rate. Using the water plugging rate and permeability coefficient as performance indexes to evaluate the water plugging and anti-seepage effects of seepage grouting in a water-rich sand layer and four factors of sand layer particle size, hydrodynamic pressure, grouting pressure, and cohesive soil content as influencing factors of seepage grouting, the orthogonal test of water plugging and anti-seepage effects of seepage grouting in a sand layer is carried out. The main controlling factors affecting the effect of sand layer infiltration grouting are obtained. Simultaneously, the numerical simulation of the model test was carried out, focusing on the change process of pressure, flow rate and slurry diffusion in the slurry-water two-phase seepage field during the grouting process, and the comparison with the experimentally measured slurry diffusion distance was verified. The results show that:(1) after the water-rich sand layer is grouted with permeable polymer, the water plugging rate can reach more than 90% within 10 min, and the permeability coefficient within a day can reach the order of 10 -7 cm/s, achieving the ideal water plugging and seepage control effect.(2) Within a certain range of grouting pressure, the grouting pressure is the primary control factor for controlling the water plugging and anti-seepage effects of grouting in water-rich sand layers. The water plugging rate increases within 10 min as the grouting pressure increases, and the permeability coefficient of the sand layer within a day decreases significantly.(3) When the slurry reaction is complete, the pore water pressure in the part of the sand layer where the slurry can diffuse is close to zero.(4) The numerical simulation results show that the pressure field of slurry-water two-phase seepage decreases from the grouting hole to the water discharge boundary, the seepage velocity of the downstream section is significantly larger than that of the upstream section, the slurry has the phenomenon of backwater diffusion, and the diffusion distance simulation results have little error with the measured results of the consolidation body.(5) The regression equations of grout plugging rate, 1 d permeability coefficient of consolidation body with dynamic water pressure,grouting pressure, sand layer grain size, and clay content were obtained by multiple linear regression analysis.