Abstract:Highlights • Established a new slope mass rating classification method for sandy dolomite slopes which is named SMR SDS , indices of which include the sandy grade, joint state, groundwater condition and excavation method. • The SMR SDS method is applied in eight sandy dolomite slopes, and the results are closer to the actual situation than BQ and SSPC methods. Meanwhile, the SMR SDS method considers the characteristics of sandy dolomite, and it can evaluate the stability of sandy dolomite slopes on site quickly and accurately. • The SMR SDS method can help advance subsequent research on sandy dolomite slopes. Although disintegrated dolomite, widely distributed across the globe, has conventionally been a focus of research in underground engineering, the issue of slope stability issues in disintegrated dolomite strata is gaining increasing prominence. This is primarily due to their unique properties, including low strength and loose structure. Current methods for evaluating slope stability, such as basic quality (BQ) and slope stability probability classification (SSPC), do not adequately account for the poor integrity and structural fragmentation characteristic of disintegrated dolomite. To address this challenge, an analysis of the applicability of the limit equilibrium method (LEM), BQ, and SSPC methods was conducted on eight disintegrated dolomite slopes located in Baoshan, Southwest China. However, conflicting results were obtained. Therefore, this paper introduces a novel method, SMR DDS , to provide rapid and accurate assessment of disintegrated dolomite slope stability. This method incorporates parameters such as disintegrated grade, joint state, groundwater conditions, and excavation methods. The findings reveal that six slopes exhibit stability, while two are considered partially unstable. Notably, the proposed method demonstrates a closer match with the actual conditions and is more time-efficient compared with the BQ and SSPC methods. However, due to the limited research on disintegrated dolomite slopes, the results of the SMR DDS method tend to be conservative as a safety precaution. In conclusion, the SMR DDS method can quickly evaluate the current situation of disintegrated dolomite slopes in the field. This contributes significantly to disaster risk reduction for disintegrated dolomite slopes.

Point Load Strength Test Power Index of Irregular Sandy Dolomite Blocks

Development of empirical equations between uniaxial compressive strength and point load index: a case study for sandy dolomite

A New Index for Evaluating Liquefaction Resistance of Soil under Combined Cyclic Shear Stresses

Case study: using the point load test to estimate rock strength of tunnels constructed by a tunnel boring machine

Study on the mechanical properties of anisotropic red sandstone under point load strength test and uniaxial compression strength

Experimental investigation of rock strength using indentation test and point load test

Estimation of Elastic Modulus of Rock Using Modified Point-Load Test

Strength interpretation parameter of piezoncone penetration test for soft clay in offshore area of Hangzhou Bay

A Destructive Field Study on the Behavior of Pile under Ten

Method of equivalent core diameter of actual fracture section for the determination of point load strength index of rocks

Shear Modulus and Damping Ratio of Sand–Gravel Mixtures Over a Wide Strain Range

Mechanical Properties of Strongly Weathered Rock–Soil Mixtures with Different Rock Block Contents

Degradation Characteristics and Mechanism of Black Sandy Dolomite with Fluid Added in a Mechanical Test

Dynamic Mohr–Coulomb and Hoek–Brown strength criteria of sandstone at high strain rates

Strength and Elastic Properties of Sandstone under Different Testing Conditions

Case Study on Failure Mode of Medium-Weathered Mudstone Based on PLT-BVM Methods and Its Bearing Capacity

An Index for Estimating the Stability of the Layered Rock Masses under Excavation Disturbance

Dynamic Mechanical Response and Dissipated Energy Analysis of Sandstone under Freeze-Thaw Cycles

Classification and rating of disintegrated dolomite strata for slope stability analysis

Experimental study on the punching failure model of soft red rock subgrade by BPT-BVM methods and it's assessment of the load bearing capacity

Study on the Weakening Law and Classification of Rock Mass Damage under Blasting Conditions