Temperature- and Stress-Dependent Electromechanical Properties of Phase Boundary Engineered (K,na)nbo3-Based Lead-Free Piezoceramics

Ahmed Gadelmawla,Udo Eckstein,Kevin Riess,Yi-Xuan Liu,Ke Wang,Jing-Feng Li,Ken-ichi Kakimoto,Neamul H. Khansur,Kyle G. Webber
DOI: https://doi.org/10.1111/jace.18917
IF: 4.186
2023-01-01
Journal of the American Ceramic Society
Abstract:The influence of stress on the small-signal dielectric permittivity and piezoelectric coefficient of polycrystalline lead-free perovskite 0.92(Na1/2K1/2)NbO3-(0.08 - x)Bi1/2Li1/2TiO3-xBaZrO(3) (x = 0, 0.02, 0.04, 0.06, and 0.07) was characterized under different constant uniaxial stress up to -200 MPa within a temperature range of -150 to 450 degrees C, revealing stress-induced suppression of the electromechanical response as well as shifts in the phase boundaries. For all compositions, the interferroelectric and ferroelectric-paraelectric phase transitions were shifted to higher temperatures under the uniaxial compressive stress. Interestingly, the sensitivity to the applied stress was found to increase with increasing BZ/BLT ratio in the system. The origin of a different extent of stress-sensitivity with BZ/BLT ratio is suggested to be related to the change in the crystal structure. Additionally, at temperatures below -50 degrees C, the relative permittivity showed a significant increase under applied compressive stress.
What problem does this paper attempt to address?