Abstract:A temperature and humidity independent control (THIC) system is a promising solution for hot and humid indoor working environments. This study proposes a dual-source heat pump air-conditioning (DSHPAC) system composed of a dual-source heat pump (DSHP) and air handling unit (AHU) as a THIC system. The proposed THIC system indirectly adjusts the cooling capacity of the high-temperature evaporator (Eva1) and low-temperature evaporator (Eva2) by controlling the refrigerant mass flow rate of the system to meet the cooling and dehumidifying requirements under different operational conditions. The proposed THIC system can switch among three operational modes by using the designed operational strategy, ensuring that the requirements for indoor temperature and humidity are met. In addition, the mathematical model and equilibrium equations of the THIC system are established. This study uses an office building in Xi'an on a typical summer day as a simulation case in dynamic simulations. The coefficient of performance (COP), cooling capacity, and compressor power consumption of the proposed DSHP system are analyzed. The results demonstrate that the COP of the proposed system increases with the temperature of Eva1 (TEva1), the COP of the proposed system varies from 1.76 to 3.62, and the cooling capacity increases from 1.19 kW to 3.38 kW when TEva1 increases from 6.24 degrees C to 36.4 degrees C. The analysis of different values of phi R (refrigerant mass ratio) shows that the highest COP is achieved at phi R = 0.1. The results prove the application potential of the dual-source heat pumps to the THIC air-conditioning systems.

Adaptive finite-time fan-coil outlet wind temperature control for the ASHPAC system

Adaptive Fan-coil Outlet Wind Temperature Control with Correction Module of Thermistor for the ASHPAC System

A neural network based temperature control for air handling unit

Air-source Heat Pump Heating System with a New Temperature and Hydraulic-Balance Control Strategy: A Field Experiment in a Teaching Building

GA Optimized Fuzzy PID Control with Modified Smith Predictor for HVAC Terminal Fan System

Fuzzy PID Combined with Smith Predictor Control of GSHP Terminal Fan System

Analysis of air source heat pump with small temperature difference fan-coil units for high efficient and comfort heating

An Adaptive Artificial Neural Network-Based Supply Air Temperature Controller for Air Handling Unit

Investigation on the performance of ASHP heating system using frequency-conversion technique based on a temperature and hydraulic-balance control strategy

Performance Investigation on an Air Source Heat Pump System with Latent Heat Thermal Energy Storage

Application of self-adaptive fuzzy PI control in the air-conditioning system

An Extension Theory-Based Fault Diagnosis Method for an Air Source Heat Pump

Simulation Study on Performance of an Air Source Heat Pump System Combined with Phase Change Thermal Storage Using Alternative Refrigerants

Performance Optimization of Space Heating Using Variable Water Flow Air Source Heat Pumps As Heating Source: Adopting New Control Methods for Water Pumps

Analysis of an Air Source Heat Pump Space Cooling System under Variable Inlet Water Temperature Condition

Neural-Based Air-Handling Unit For Indoor Relative Humidity And Temperature Control

Effect of reversely-variable circuitry on finned-tube heat exchanger performance in air source heat pump under annual performance factor (APF) conditions

A Robust and Self-adaptive Fuzzy-PID Controller for Temperature Control of Air Conditioning Systems

Development of an adaptive Smith predictor-based self-tuning PI controller for an HVAC system in a test room

Adaptive Predictive Control Method for Improving Control Stability of Air-Conditioning Terminal in Public Buildings

A Dynamic Simulation Study of Temperature and Humidity Independent Control System for Temperate Semi-Humid Continental Monsoon Climate Regions