Abstract:Supercritical carbon dioxide power cycle is considered as one of the promising systems of next generation power cycle. Nevertheless, the hydraulic characteristics of typical heat source components under operating conditions (gas-like region) are not clear, and the present conclusions for flow characteristics of non-isothermal fluids are also not consistent. In this work, the turbulent flow of supercritical CO2 in a vertical upward tube was studied experimentally and numerically. The range of experiment parameters was set as 750–2800 kg/(m2s) of mass flux, 10–28 MPa of pressure, 200–410 kW/m2 of heat flux and 65–500 °C of bulk flow temperature. Furthermore, the feasibility of SST k-omega model was verified by experiment results. The effects of mass flux and pressure on friction pressure drop under non-isothermal conditions are basically consistent with those under isothermal conditions. However, the increase of heat flux leads to the decrease of friction pressure drop and friction factor. Under high heat flux condition, both the viscous shear stress and Reynolds shear stress decrease. The viscous shear stress contributes slightly to the mechanical energy dissipation, hence the Reynolds shear stress is the crux to the change of friction pressure drop. Further studies show that the decrease of density in near-wall region and the decrease of turbulence fluctuation in core region are critical to the decrease of mechanical energy dissipation. According to the theoretical and dimensional analysis, the dimensionless number Xi that can be qualitatively analyzed for the ratio of thermally-induced force to inertial force was obtained. Finally, a high-precision correlation of friction factor was proposed. The proportion of calculated value within 10% and 30% error ranges is 76.65% and 100%, respectively.

Effects of Surface Roughness on Windage Loss and Flow Characteristics in Shaft-Type Gap with Critical CO2

Roughness Effects on Flow Losses of a High-Lift Low-Pressure Turbine Cascade

Wind Effects on Rough-Walled and Smooth-Walled Large Cooling Towers

Frictional Resistance Investigation of Sco2 and a Semi-Empirical Friction Factor Correlation Based on Wall-of-the-law

Effect and Mechanism of Roughness on the Performance of a Five-Stage Axial Flow Compressor

Model of Skin Friction Coefficient in a Supercritical CO 2 Turbine-Alternator-Compressor Unit

Numerical Study of Two Types of Rough Groove in Suppressing the Tip Clearance Cavitation

Flow of Power-Law Fluid Past a Circular Cylinder in the Vicinity of a Moving Wall

Investigation of the Discharge Coefficient for Laidback Fan-Shaped Holes on Turbine Blades Under Internal Crossflow Condition

Effects of Roughness on Fluid Flow Behavior in Ducts

Effects of annular-cooler surface-roughness on wind resistance and thermal environment in a high-speed geotechnical centrifuge chamber

Effect of chamber roughness and local smoothing on performance of a CAES axial turbine

Numerical investigation of distributed roughness effects on separated flow transition over a highly loaded compressor blade

Effect of the key geometry and flow parameters on discharge coefficient of laidback fan-shaped hole under coolant crossflow condition

Experimental study on the effect of wall roughness on heat transfer characteristics of supercritical carbon dioxide in vertical tubes

Role of wall roughness on interaction of leakage flow and main flow in a mixed flow pump with tip clearance

Experimental and numerical investigation on the effect of surface roughness on the drag coefficient of a spherical particle

Effects of surface roughness on the aerodynamic performance of a high subsonic compressor airfoil at low Reynolds number

Experimental investigation of hole-geometry effect on unsteady characteristics of film cooling at turbine vane leading edge

Effects of surface roughness on the drag coefficient of finite-span cylinders freely rolling on an inclined plane

Flow resistance analysis of non-isothermal supercritical CO2