Abstract:The ignition of timber buildings in the context of wildland-urban interface (WUI) fires has emerged as a significant challenge amidst the backdrop of global climate change. However, to the best knowledge of the authors, little attention was paid to the ignition conditions of wood building materials in WUI fires especially in thermal-fluid coupling environments. This study experimentally investigated the smoldering and flaming ignition characteristics of wood under the coupling effects of thermal radiation and cross winds. Surface temperature, internal temperature, mass loss rates, and time to ignition of wood samples were measured to study their variation with the above factors and the threshold between smoldering and flaming ignition phenomena. The results showed that wood exhibited reduced susceptibility to flaming ignition under low radiant heat flux conditions, and the introduction of cross winds posed more challenges for flaming ignition. In addition, both the critical surface temperature and mass loss rate varied with radiant heat flux and cross-wind speeds, so it was not feasible to determine the occurrence of flaming ignition by any of the two factors directly. This is because the coupling effects of thermal radiation and cross winds would result in a competition between radiant heating and convective cooling on wood surfaces. In light of this fact, two dimensionless quantities, namely Damk & ouml;hler number and heat transfer ratio, were introduced to distinguish between smoldering and flaming ignitions. Damk & ouml;hler number was used as an indicator of the potential for gas-phase flaming ignition, while the heat transfer ratio, namely the ratio of convective heat loss to radiant heat flux, was used to measure the net thermal energy received by wood surfaces. It has been demonstrated that the two quantities were effective to distinguish between smoldering and flaming ignitions from the perspectives of gas and solid phases with 20-40 kW/m(2) in radiant heat flux and 0-1.0 m/s in cross-wind speed. The data and theories disclosed in this study could help predict the ignition behaviors of timber buildings under thermal-fluid coupling conditions, thus providing useful guidance for WUI fire mitigation and control.

Arc Bead Ignition of a Cellulose Fuel Bed Derived from Experimental and Simulated Data

Ignition ability prediction model of biomass fuel by arc beads using logistic regression

Smoldering and Spontaneous Transition to Flaming over Horizontal Cellulosic Insulation

Ignition of Pine Needle Fuel Bed by the Coupled Effects of a Hot Metal Particle and Thermal Radiation

Effect of porosity on ignition and burning behavior of cellulose materials

Computational study of the effects of density, fuel content, and moisture content on smoldering propagation of cellulose and hemicellulose mixtures

Experimental Study on Flaming Ignition of Pine Needles by Simulated Lightning Discharge

Experimental Study of Ignition Process Caused by Poor Electrical Contact of Connecter

An Experimental and Numerical Study on Fire Behaviors of Charring Materials Frequently Used in Buildings

Flame Spread and Burning Rates Through Vertical Arrays of Wooden Dowels

Smoldering combustion in cellulose and hemicellulose mixtures: Examining the roles of density, fuel composition, oxygen concentration, and moisture content

Experimental and Theoretical Study on Horizontal Flame Spread Through Arrays of Wooden Dowels

Experimental Study on the Ignition Behavior of Wildland Fuels Ignited by Heated Stainless-Steel Particles

Experimental Study of the Ignition of Wood Exposed to a Variable Heat Flux

Modelling Bench-Scale Fire on Engineered Wood: Effects of Transient Flame and Physicochemical Properties

Interaction Between Flaming and Smouldering in Hot-Particle Ignition of Forest Fuels and Effects of Moisture and Wind

Ignition Limits of Pine Wood Building Material under the Coupling Effects of Thermal Radiation and Cross Winds

Analysis and Modeling of Ignitability of Polymers in the UL-94 Vertical Burning Test Condition

Experimental Study On Extinguish Behaviors Of Flame Spreading Downward Over Charring Solid

Thermal and kinetic analyzing of pyrolysis and combustion of self-heating biomass particles

Comprehensive investigations on the explosion suppression of biomass fuels: Starch as a representative