Abstract:According to the engineering application requirements of special-shaped section penetrating projectiles, the structural response and optimal design of elliptical-section penetration projectiles were studied. From this point of view, an improved general design method of elliptical-section projectiles was developed by introducing a dimensionless cartridge thickness coefficient of the elliptical projectile. In order to improve the inertia moment and static moment to the short axis of the cross-section, a bending optimization design method of the elliptical-section projectile was proposed by reducing the cartridge thickness of the projectile to a certain extent and redistributing the reduced materials. Based on a 152-mm-diameter light gas gun test device, the reverse tests of three kinds of elliptical-section hollow projectiles with the long axis of 1.8 cm and the short axis of 1.2 cm penetrating a 2024-O aluminum target were carried out, and the responses of the projectiles in the penetration process were obtained. The projectiles after tests were collected by the soft recovery method, and the deformation of the central axes of the projectile was obtained by the gray processing method. Numerical simulations of the tests were carried out by LS-DYNA. The stress, strain, and penetration load of the projectiles during the penetration process were obtained, and the equivalence of the normal ballistic test and reverse ballistic test was verified. Based on the free-free beam theory, a bending response calculation model of the elliptical-section projectile was established. Through the optimized design, the inertia moment to the short axis of the elliptical section increases by 16.44%, and the static moment increases by 15.95%. Under the test conditions, the bending deflection of the projectile decreases by 25.25%. The structural response model was used to calculate the projectile deformation under the test conditions. The calculation results of the theoretical model are in good agreement with the test results, which shows that the calculation method of the model has a certain accuracy and can provide a reference for engineering design.

Three-dimensional Trajectory Prediction and Analysis of Elliptical Projectile

Trajectory Prediction of the Tapered Projectile and Grooved Projectile in Deep Penetration

Trajectory prediction of rigid projectile for oblique penetration into multi-layer aluminum targets

Design and Optimization of Wavy Trajectory for Ballistic Missiles

A Rigid Elliptical Cross-Sectional Projectile with Different Geometrical Characteristics Penetration into Concrete Target

Three-dimensional Trajectory Tracking Guidance Law Based on Linear Quadratic Regulator

Structural optimization design and structural response of elliptical-section penetration projectiles

Trajectory Simulation of a Spinning Projectile Based on CFD/RBD Computation Method

Three-dimensional Impact Angle Control Guidance with Field-of-view Constraint

Impacts of Deflection Nose on Ballistic Trajectory Control Law

The Analysis of Impact Between Projectile and Barrel in Bore

Numerical Simulation of Thin Steel Target Perforated by Conical-Nosed Projectile with Yaw Angle

Simulation of Three-Dimensional Dynamic Trajectory of Missile Based on Matlab

Three-dimensional numerical analysis about influences of atmospheric wind field on ballistic trajectory

Energy dissipation analysis of elliptical truncated oval rigid projectile penetrating stiffened plate

A Computational-Geometry-based 3-Dimensional Guidance Law to Control Impact Time and Angle

Study on Penetration Law of Special-shaped Projectile to Soil Target With Finite Thickness

Study on Penetration Characteristics of High-speed Elliptical Cross-sectional Projectiles into Concrete

Modified shape-based method for three-dimensional trajectory design

Preformed Fragment Velocity Distribution of Elliptical Cross-section Projectile