Layer-by-Layer Assembly of CeO 2– x @C-rGO Nanocomposites and CNTs as a Multifunctional Separator Coating for Highly Stable Lithium–Sulfur Batteries
Yulei Li,Xiaofei Zhang,Qi Zhang,Jiewu Cui,Xin Liang,Jian Yan,Jiaqin Liu,Hark Hoe Tan,Yan Yu,Yucheng Wu
DOI: https://doi.org/10.1021/acsami.2c03461
2022-04-12
Abstract:Commercialization of high-energy Li–S batteries is greatly restricted by their unsatisfactory cycle retention and poor cycling life originated from the notorious "shuttling effect" of lithium polysulfides. Modification of a commercial separator with a functional coating layer is a facile and efficient strategy beyond nanostructured composite cathodes for suppressing polysulfide shuttling. Herein, a multilayered functional CeO2–x@C-rGO/CNT separator was successfully achieved by alternately depositing conductive carbon nanotubes (CNTs) and synthetic CeO2–x@C-rGO onto the surface of the commercial separator. The cooperation of multiple components including Ce-MOF-derived CeO2–x@C, rGO, and CNTs enables the as-built CeO2–x@C-rGO/CNT separator to perform multifunctions from the separator surface: (i) to hinder the diffusion of polysulfide species through physical blocking or chemical adsorption, (ii) to accelerate the sluggish redox reactions of sulfur species, and (iii) to enhance the conductivity for sulfur re-activation and efficient utilization. Serving as a multilayer and powerful barrier, the CeO2–x@C-rGO/CNT separator greatly constrains and reutilizes the polysulfide species. Thus, the Li–S battery assembled with the CeO2–x@C-rGO/CNT separator demonstrates an excellent combination of capacity, rate capability, and cycling performances (an initial capacity of 1107 mA h g–1 with a low decay rate of 0.060% per cycle over 500 cycles at 1 C, 651 mA h g–1 at 5 C) together with remarkably mitigated self-discharge and anode corrosion. This work provides guidelines for functional separator design as well as rare-earth material applications for Li–S batteries and other energy storage systems.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.2c03461.TG analysis for Super-P/sulfur composite; SEM morphology of Ce-MOF and Ce-MOF-GO; SEM images coupled with EDX mappings of CeO2–x@C; XPS data of CeO2–x@C-rGO and CeO2–x@C; XPS data of CeO2–x@C-rGO after Li2S6 adsorption; surface model of CeO2(111), CeO2–x (111), and rGO(001); top-surface SEM images of pristine and CeO2–x@C-rGO/CNT separators; CV curves, equivalent circuits coupled with EIS simulation results, and charge–discharge profiles of batteries based on different separators; and electrochemical performance comparison of Li–S batteries based on different functional separators (PDF)This article has not yet been cited by other publications.
materials science, multidisciplinary,nanoscience & nanotechnology