Selective reduction of NO3− to N2using a highly stable Cu0/Cu2O-PANI-CNTs as a photocatalyst at neutral pH
Li Cai,Xuemei Zhang,Qian Wang,Yong Liu
DOI: https://doi.org/10.1016/j.cej.2023.146261
IF: 15.1
2023-11-01
Chemical Engineering Journal
Abstract:The selective photoreduction of nitrate (NO3 −) to nitrogen (N2) has emerged as an energy-efficient and environmentally friendly NO3 − removal route under mild conditions. However, NO3 − photoreduction often suffers low NO3 − removal efficiency in the absence of hole scavengers at neutral pH, the generation of undesired side products (nitrite (NO2 −), ammonium (NH4 +), nitrogen oxides (NOx), etc.) and poor photocatalyst stability. In this study, a novel copper/copper(I) oxide-polyaniline-carbon nanotubes (Cu0/Cu2O-PANI-CNTs) photocatalyst was prepared through a combination of in situ polymerization and liquid phase reduction processes and used to reduce NO3 − to N2. In the Cu0/Cu2O-PANI-CNTs/hv system, NO3 − was reduced to NO2 − by photogenerated electrons (ecb −) on the surface of Cu0/Cu2O, and the generated NO2 − was further reduced to N2 by PANI, resulting in high N2 selectivity. –NH– in PANI acted as photogenerated hole (hvb +) capture centres, leading to NO3 − photoreduction without additional hole scavengers. Given the interaction between Cu0, ecb − and PANI, Cu0/Cu2O-PANI-CNTs show excellent repeatability. A 100% NO3 − removal efficiency and 100 % N2 selectivity could be achieved by the Cu0/Cu2O-PANI-CNTs/hv system at neutral pH. With river water, secondary effluent and the fourth reuse of the catalyst, the NO3 − removal efficiencies were as high as 93.0%, 91.2% and 84.4%, respectively, with 100 % N2 selectivity.
engineering, chemical, environmental