Abstract:Single-phase liquid-cooled heat sinks are a preferred mode of thermal management for many power dense electronic applications. This paper studies the design, optimization, and thermal-hydraulic performance of polymer manifolds directing coolant to the base plate of multi-chip power modules. Direct cooling eliminates the need for thermal interface materials which form a major bottleneck to junction-to-coolant thermal resistance reduction in state-of-the-art metallic cold plates. We use 2D topology optimization (TO) to develop designs using side view (SVTO) and top view (TVTO) sections of the flow domain in contact with the power module base plate. We also use 3D TO design (CTO) which combines SCTO and TVTO. The TO designs are compared against conventional mini-channel designs including rectangular, zig-zag and serpentine channels. Cooling performance of the different designs is computed using computational fluid dynamic (CFD) simulations. Experimental quantification is achieved through measurements of the silicon carbide device junction temperature and inter-device temperature difference along with the pressure drop influencing the pumping power requirement. The CFD simulations were used to identify optimized manifold designs which were fabricated using selective laser sintering of PA12 and validated experimentally using surrogate heaters. Zig-zag designs showed the best performance among the conventional designs (0.93 (cm 2 ·K)/W), at the cost of high pressure drop (> 2.4 kPa). Serpentine channel designs were effective in limiting inter-device temperature difference (< 0.260C) through multiple changes of flow direction. The TO designs improved the performance (1.1 (cm 2 ·K)/W) when compared against conventional channels showing lower maximum temperatures with lower pressure drops (0.8 kPa). Fluid manifolds are shown to greatly influence the coolant flow field, leading to flow maldistribution with low velocity pockets, emphasizing the need for optimizing the complete manifold design.

Cooling of High Heat Flux Miniaturized Electronic Devices Using Thermal Ground Plane: an Overview

A review of the cooling methods based on IGBT module and the application of micro-channel cooling in IGBT Chinese Full Text

Engineered Nanostructures for High Thermal Conductivity Substrates

Thermal-Fluid Modeling for High Thermal Conductivity Heat Pipe Thermal Ground Planes

Development And Experimental Validation Of A Micro/Nano Thermal Ground Plane

Charging Station of a Planar Miniature Heat Pipe Thermal Ground Plane

An overview of conjugate heat transfer augmentation methods for thermal management and recent advancements in microchannel heat sink overall performance

State-of-the-Art Cooling Solutions for Electronic Devices Operating in Harsh Conditions

Thermal Management Technologies Used for High Heat Flux Automobiles and Aircraft: A Review

Advancing thermal management in electronics: a review of innovative heat sink designs and optimization techniques

A comprehensive review on thermal management of electronic devices

Applications of Microfluidic Devices for Electronics Thermal Management

On the Charging and Thermal Characterization of a Micro/nano Structured Thermal Ground Plane

Alternating Current Electrothermal Flow for Energy Efficient Thermal Management of Microprocessor Hot Spots

Glacierware: Hotspot-aware Microfluidic Cooling for High TDP Chips using Topology Optimization

Recent Advances in Thermal Interface Materials for Thermal Management of High-Power Electronics

Conventional and topologically optimized polymer manifolds for direct cooling of power electronics

Liquid Metal Based Miniaturized Chip-Cooling Device Driven by Electromagnetic Pump

Thermal Characterization and Wick Optimization of Mini-Grooved Flat Heat Pipe for Electronics Cooling

Transient Heat Transfer Characteristics in a Flat Plate Heat Sink with Mini-Channels for Cooling High Heat Flux IGBT

Recent advances in polymer-based thermal interface materials for thermal management: A mini-review