Abstract:A trade-off inevitably exists between soot and NOx emissions in a traditional engine. The addition of an oxygen containing biofuel can decrease the soot emission but increase the NOx emission. Multi-injection strategy can be used to decrease the NOx emission. Therefore, both simulations and experimental tests were conducted to evaluate the influences of pre-injection on the combustion and emission characteristics of pure diesel (D100) and diesel/n-butanol (30% n-butanol and 70% diesel by volume, B30). The results showed that as the pre-injection interval decreased, the in-cylinder pressure peak increased, the pre-injection heat release ratio increased, and the brake-specific fuel consumption (BSFC) decreased. Only at a small pre-injection interval, the BSFC under pre injection condition was lower than that obtained using the single injection strategy. When the same pre-injection strategy was used, B30 had a higher BSFC and lower brake thermal efficiency than D100. The soot emission decreased with the increase in pre-injection interval but increased with the increase in pre-injection ratio. More soot was emitted using the pre-injection strategy than that using single injection strategy. B30 had a lower soot emission than D100 due to a longer ignition delay. As the pre-injection interval increased, the decreasing amplitude of NO production became smaller than the increasing amplitude of NO2 production, thus increasing the net NOx emission. As the pre-injection ratio increased, more CO was produced through the reaction paths CH2O -> HCO -> CO, whereas the transformation of CO to CO2 almost remained unchanged, thus increasing the net CO emission. The increase in pre-injection ratio inhibited the oxidation of CO to CO2 and thus increased the CO emission. The amount of unburned hydrocarbons increased with the increase in both pre-injection ratio and interval.

Experimental Study on the Effects of Injection Timing and N-Butanol Energy Ratio on Combustion and Emissions of N-Butanol/diesel DFDI Engine

Impact mechanism of double injection on the combustion and emission characteristics of n-butanol/diesel dual fuel direct injection engine

Emission, efficiency, and influence in a diesel n-butanol dual-injection engine

Experimental and Simulation Investigation of the Combustion Characteristics and Emissions Using N-Butanol/biodiesel Dual-Fuel Injection on a Diesel Engine

Effects of Injection Timing and Pressure on Combustion and Emissions on an Engine Fueled with Diesel/Gasoline/n-Butanol Blends

Experimental Study of N-Butanol Additive and Multi-Injection on HD Diesel Engine Performance and Emissions

Feasibility study of the combustion strategy of n-butanol/diesel dual direct injection (DI2) in a compression-ignition engine

Experimental Study of the Bioethanol Substitution Rate and the Diesel Injection Strategies on Combustion and Emission Characteristics of Dual-Fuel-direct-injection (DFDI) Engine

Investigation on the Effects of Pilot Injection on Low Temperature Combustion in High-Speed Diesel Engine Fueled with N -Butanol–diesel Blends

Effects of Gasoline and Iso-Butanol Addition on Combustion and Pollutant Emissions of a Common-Rail Diesel Engine at Different Injection Timing

Numerical study on the combustion and emission characteristics of a direct injection natural gas engine ignited by diesel/n-butanol blends

Potential of N-Butanol/diesel Blends for CI Engines under Post Injection Strategy and Different EGR Rates Conditions

Combustion Performance of Dual-Injection Using N-Butanol Direct-Injection and Gasoline Port Fuel-Injection in a SI Engine

Effect of Premixed N-Butanol Ratio on the Initial Stage of Combustion in a Light-Duty Butanol/Diesel Dual-Fuel Engine

Study on the effect of injection strategy on the combustion and emission characteristics of direct injection spark ignition bio-butanol engine

An Experimental Study of the Injection Strategies on Engine Performance of the Butanol/biodiesel Dual-Fuel Intelligent Charge Compression Ignition Mode

Direct Injection of Neat N-Butanol for Enabling Clean Low Temperature Combustion in a Modern Diesel Engine

Experimental and Numerical Study of Pre-Injection Effects on Diesel-N-butanol Blends Combustion

Multiple Combustion Modes Switching to Realize Full-Load Efficient Energy Conversion of N-Butanol/diesel Dual Direct Injection (DI2) Engine

Temperature, Combustion, and Emissions on a Diesel Engine Using N-Butanol/Diesel Compound Combustion Mode

Effects of Port Fuel Injection (PFI) of N-Butanol and EGR on Combustion and Emissions of a Direct Injection Diesel Engine