Effect of Photonic Crystal Film As Support on Enhancement of Graphite-Carbon Nitride Quantum Dots Sensitized Bi2MoO6 Photocatalytic Activity

Liu Ruizhen,Wang Qing,Li Ping,Jiang Huaiyuan,Mai Binglin,Zhao Liuyong,Zhang Zhiqi,Fan Yutian,Cheng Jian,Lyu Renliang
DOI: https://doi.org/10.1007/s10971-022-05994-8
2022-01-01
Journal of Sol-Gel Science and Technology
Abstract:Photonic crystals (PCs) with slow photon effect and multiple scattering for its three-dimensional ordered structure have been applied to improve light utilization and enhance photocatalytic activity. A ternary-structured photocatalyst was prepared. Bi2MoO6 was first sensitized by graphite-carbon nitride quantum dots (g-CNQDs) by in situ coupling via a hydrothermal method. The best performance of Bi2MoO6/g-CNQDs was 3.56 times higher than that of Bi2MoO6. The introduction of g-CNQDs improved both the light absorption range and charge transfer efficiency for Bi2MoO6/g-CNQDs composites. Furthermore, because of the combination of the g-CNQDs with the Bi2MoO6 nanosheets, the separation efficiency of photogenerated carriers was improved and the recombination rate was greatly reduced. To further improve light utilization, SiO2 PCs were composited to the above Bi2MoO6/g-CNQDs by spin coating to obtain ternary-structured Bi2MoO6/g-CNQDs/SiO2 PCs. The effect of the photonic band gap (PBG) of PCs on photocatalytic activity was investigated, and the photocatalytic activity was highest when the PBG was located near the absorption peak of g-CNQDs at 464 nm, which was 5.56 times higher than that of pure Bi2MoO6. The farther the photonic PBG is away from the absorption edge of g-CNQDs, the lower the photocatalytic activity of the composite membranes. This work provides a way to construct multiple-structured photocatalysts with high photocatalytic activity and confirms that PCs with precisely tuned band gap will substantially enhance the activity of photocatalysts.
What problem does this paper attempt to address?