Broadband Doherty Power Amplifier Using Short Ended Λ/4 Transmission Lines Based on the Analysis of Negative Characteristic Impedance

Xu,Hang Chen,Wenhua Chen,Xiu Yin Zhang

DOI: https://doi.org/10.1109/tcsi.2022.3221926

2022-01-01

IEEE Transactions on Circuits and Systems I Regular Papers

Abstract:This paper presents a broadband Doherty power amplifier (DPA) using quarter-wavelength ( $\lambda $ /4) transmission lines with negative characteristic impedance. In conventional DPA designs, the load modulation network is frequency-dependent, leading to bandwidth limitation at the back-off power region. In this design, by integrating two $\lambda $ /4 transmission lines with negative characteristic impedance into the main and auxiliary branches, the impedance at the back-off power can be manipulated to maintain high efficiency at back-off power over a wide frequency range. Thus, the operational bandwidth is extended. In circuit realization, the two negative characteristic impedance $\lambda $ /4 transmission lines are replaced by paralleled negative LC components. Then, the negative capacitor is combined into the $\pi $ -shaped impedance matching network, while the negative inductor is eliminated by introducing Norton transformation. For verification, a broadband DPA with a fractional bandwidth of 108.6% from 0.8 to 2.7 GHz is implemented. The measured saturated output power is 41.8-44 dBm. The saturated and 6-dB back-off power drain efficiencies are 47.6%-84.4% and 39.5%- 52%, respectively. A 20-MHz LTE modulated signal with peak-to- average power ratio (PAPR) of 7.5 dB is also applied to measure the fabricated DPA. After digital predistortion, the adjacent channel leakage ratio (ACLR) better than −45.35 dBc is achieved, and the measured average efficiency is higher than 40% within the operating band.