Abstract:In laminar hypersonic boundary layers, it is known that secondary instability plays a crucial role in transition to turbulence. The secondary instability usually includes the fundamental mode, the subharmonic mode, and the detuned mode. Considerable research exists on the secondary instability mechanism in hypersonic boundary layers with the smooth wall condition. The topic of using micro-porous surfaces for disturbance stabilization has recently drawn interest. The stabilization and, thus, a possible delay in the transition arise due to a reduction in the growth rate of the primary Mack mode by the porous surface. This paper focuses on investigating whether the secondary instability mechanism of Mack modes can also be affected by a surface porosity condition. It is known that the primary Mack mode linear disturbances are changed significantly on the porous surface, and how it subsequently influences the secondary instability of the modified time varying basic flow is our concern. The analysis demonstrates that on the porous surface, as the amplitude of the primary Mack mode increases, the fundamental mode is not stable. Instead, the fundamental mode amplifies rapidly with increasing primary amplitudes. At larger secondary instability spanwise wavenumbers, when the primary amplitude exceeds a certain threshold value, the fundamental modes surpass the subharmonic modes and dominate the secondary instability. However, when the spanwise wavenumber is relatively small, especially at the spanwise wavenumber corresponding to the maximum growth rate of the subharmonic mode, the fundamental modes are weakened and lose their dominant position. We find that corresponding to different amplitudes of primary Mack mode disturbances affected by the porosity parameters, there are no strongly preferred interaction modes that dominate the secondary instability; this contrasts with smooth wall findings. We further find that the larger the pore size or porosity, the more severe the suppression of the fundamental mode.

Double-layer Acoustic Metasurface for the Suppression of the Mack Second Mode in Hypersonic Boundary-Layer Flow

Impedance-Near-Zero Acoustic Metasurface for Hypersonic Boundary-Layer Flow Stabilization

Control of Reflected Waves with Acoustic Metasurfaces for Hypersonic Boundary-Layer Stabilization

Stabilization Mechanisms of Various Acoustic Metasurfaces on the Second Mode in Hypersonic Boundary-Layer Flows

Ultra-compact Reflective Metasurface for Wave Manipulation

Broadband Design of Acoustic Metasurfaces for the Stabilization of a Mach 4 Boundary Layer Flow

Predicting the Ultrasonically Suppressive Behavior of Acoustic Metasurfaces

Effect of Acoustic Metasurface on Hypersonic-Boundary-layer Wave Packet

Composite Sub-Wavelength Acoustic Metasurfaces for Acoustic Mode Attenuation

Acoustic Metasurface by Layered Concentric Structures

Stabilization Effect of Acoustic Metasurfaces on Broadband Disturbances in a Mach 6 Boundary-Layer Flow

Review of acoustic metasurfaces for hypersonic boundary layer stabilization

Reverse Design of Ultrasonic Absorptive Coating for the Stabilization of Mack Modes

Broadband Suppression of Aerodynamic Pressure on the High-Speed Bluff Body Surface with Periodic Square-Cavity Acoustic Metasurface

Acoustic metasurface embedded with thin-walled plate based on phase modulation for multi-angle broadband sound absorption

Aerodynamic Noise Control with an Acoustic Metasurface Comprising an Array of Low-Flow-sensitivity Helmholtz Resonators

Secondary instability of Mack mode disturbances in hypersonic boundary layers over micro-porous surface

Effect of Two-Dimensional Micro-Cavity Surface on Hypersonic Boundary Layer

Bilayer Synergetic Coupling Double Negative Acoustic Metasurface and Cloak

Theoretical Modeling and Optimization of Porous Coating for Hypersonic Laminar Flow Control

Application of an overlay for spurious suppression of multi-layered surface acoustic wave resonators with double busbar configuration