Abstract:In order to enhance the physical basis of the mass transfer model in numerical simulation of gas-liquid direct contact condensation and improve the fidelity, a set of methods and models are developed. Based on the concept of the piecewise-linear interface calculation (PLIC), an interface reconstruction algorithm is proposed to calculate the interfacial area concentration in three-dimensional non-orthogonal structured grids. The actual interface in the cell is replaced by a plane, whose position is determined iteratively to satisfy the local volume fraction and orientation of the actual interface. The area of the polygonal cut by the plane is taken as the interfacial area in the cell. The proposed algorithm is validated by calculating the surface area of a series of basic geometries. Obvious superiority of the proposed algorithm over the traditional models (gradient model and algebraic model) is seen. Then, the reconstructed area is used to determine the interfacial area concentration in the thermal phase change model. The process is implemented by ANSYS Fluent user-defined functions. The Stefan problem and steam bubble condensation experiment are used to test the performance of the developed methods and models. The simulation results agree well with the theoretical and experimental results with the quantitative relative errors no more than 4.3 % and 15 %, respectively. The oxygen jets condensation experiments are also used as test cases. The primary dominant frequencies predicted by the simulations are 163.01 Hz and 131.65 Hz, which agree well with the 139.72 Hz and 125.75 Hz in the experiments. The relative errors are only 17 % and 4.7 %. The unstable flow pattern of oxygen jet in liquid oxygen crossflow is explained based on the dynamic characteristics of turbulence, heat and mass transfer. The periodic variation of mass transfer rate is considered as the cause of condensation oscillation. The method for calculating the interfacial area proposed in this paper can serve as an optional and practical improvement to the numerical simulation of direct contact condensation.

Modeling Filtered Heat Transfer Model by Considering Dimensionless Temperature Difference Between Gas and Solid Phases

Study of filtered interphase heat transfer using highly resolved CFD–DEM simulations

A Computational Method to Solve for the Heat Conduction Temperature Field Based on Data-Driven Approach

A Three-Dimensional Fictitious Domain Method for Direct Numerical Simulations of Particle-Laden Flows with Heat Transfer

Fully Resolved Numerical Simulation of Interphase Heat Transfer in Gas–solid Turbulent Flow

Coupled Solid-Liquid Phase Change and Thermal Flow Simulation by Particle Method

Thin liquid film flow and heat transfer under spray impingement

Numerical Simulation Of Heat And Mass Transfer In Air-Water Direct Contact Using Computational Fluid Dynamics

A compressible semi-resolved computational fluid dynamics-discrete element method coupling model for fluid–solid systems with heat transfer

Cfd -Based Modelling On Inter Facial Heat Transfer For Water Quenching

A computational fluid dynamics-discrete element-immersed boundary method for Cartesian grid simulation of heat transfer in compressible gas–solid flow with complex geometries

Simulating Heat Transfer from Moving Rigid Bodies Using High-Order Ghost-Cell Based Immersed-Boundary Method

A reduced model for compressible viscous heat-conducting multicomponent flows

Development of a modified thermal phase change model based on the interfacial area concentration determined by an interface reconstruction algorithm

A FEM-Based Inverse Calculation Method for Determination of Heat Transfer Coefficient in Liquid Quenching Process

Conventional and data‐driven modeling of filtered drag, heat transfer, and reaction rate in gas–particle flows

A Ghost-Cell Based High-Order Immersed Boundary Method for Inter-Phase Heat Transfer Simulation

DIMENSIONLESS FORMULAE FOR THERMAL STORAGE AND HEATTRANSFER IN PHASE CHANGE MATERIAL AROUND A CIRCULARTUBE WITH HEAT TRANSFER FLUID FLOWING INSIDE

A SIMPLE MODEL FOR HEAT TRANSFER ANALYSIS OF SHELL-AND-TUBE WITH PHASE CHANGE MATERIAL AND ITS PERFORMANCE SIMULATION

A Frequency Domain Dynamic Simulation Method for Heat Exchangers and Thermal Systems

Computational Fluid Dynamics Simulations of Interphase Heat Transfer in a Bubbling Fluidized Bed