Abstract:Formic acid (FA) can be considered a bridge between biomass and green fuels, as biomass can be oxidized to FA, followed by FA dehydration to CO for Fischer–Tropsch synthesis. In this work, a series of γ-Mo2N-based catalysts used for FA dehydration was prepared by the facile pyrolysis of a Mo-containing precursor at different temperatures. It was found that the γ-Mo2N-based catalysts exhibited high performance for FA dehydration to CO with a maximum selectivity of ∼99.8%, and the onset reaction temperature over the γ-Mo2N-based catalysts was also much lower (100–200 °C) than those over conventional solid acid catalysts. In particular, the γ-Mo2N obtained at a pyrolysis temperature of 625 °C exhibited the highest activity, which was followed by those of the catalysts obtained at 600, 650, and 700 °C, which was consistent with the acidities of these catalysts. However, the CO selectivity monotonically increased with the increase in the catalyst preparation temperature but decreased with the increase in the FA decomposition temperature. FA conversion decreased when the contact time between the catalyst and the FA was reduced, but conversely, the CO selectivity increased. The enhanced CO selectivity might be ascribed to dehydrogenation having comparatively lower kinetics than that of dehydration, and thus, compared to dehydration, dehydrogenation could be more apparently suppressed by the reduced contact time, resulting in a higher CO selectivity. Moreover, it was found that the γ-Mo2N catalyst had no obvious deactivation for FA dehydration over the 20 h continuous operation period.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acssuschemeng.0c03269?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acssuschemeng.0c03269</a>.GC calibration; Py-IR analysis details and results; crystallite size results; TG/MS, SEM, HRTEM, XPS, NH3-TPD characterization data (<a class="ext-link" href="/doi/suppl/10.1021/acssuschemeng.0c03269/suppl_file/sc0c03269_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Highly Efficient Conversion of Carbohydrates into Formic Acid with a Heterogeneous MgO Catalyst at Near-Ambient Temperatures

Highly Efficient One-Pot Conversion of Glucose to 5-Hydroxymethylfurfural over Acid–Base Bifunctional MCM-41 Mesoporous Silica under Mild Aqueous Conditions

Conversion of glucose to 5-hydroxymethyl furfural in water-acetonitrile-dimethyl sulfoxide solvent with aluminum on activated carbon and maleic acid

Synthesis of Biochar-Doped MgO Catalyst for Highly Efficient Conversion of Glucose into Formic Acid at Low Temperatures

Insights into the Glucose Isomerization Mechanism of Al-hydrochar Catalyst Probed by Al-oxide Species Transformation

Highly Efficient Production of 5-Methoxymethylfurfural from Fructose in Dimethyl Sulfoxide/Amberlyst-15 Catalytic System

Engineering Functional Hydrochar Based Catalyst with Corn Stover and Model Components for Efficient Glucose Isomerization

O2-H2O2 High-Efficient Co-Oxidation of Carbohydrate Biomass to Formic Acid Via Co3O4/C Nanocatalyst

Catalytic air oxidation of biomass-derived carbohydrates to formic acid.

Formation of Formic Acid from Glucose with Simultaneous Conversion of Ag2O to Ag under Mild Hydrothermal Conditions

Catalytic Conversion of Sugars to Methyl Lactate over Mg-MOF-74 in Near-Critical Methanol Solutions

Conversion of Cellulose into Formic Acid by Iron(III)-Catalyzed Oxidation with O2 in Acidic Aqueous Solutions

Efficient Catalytic Conversion of Glucose into 5-Hydroxymethylfurfural by Aluminum Oxide in Ionic Liquid

Efficient Co-Synthesis of Glycolic Acid and Formic Acid from 1,3-Dihydroxyacetone by Keggin Cesium Phosphomolybdates

Formic Acid as a Bio-CO Carrier: Selective Dehydration with γ-Mo 2 N Catalysts at Low Temperatures

Efficient isomerization of glucose into fructose by MgO-doped lignin-derived ordered mesoporous carbon

Efficient 5-hydroxymethylfurfural synthesis from carbohydrates and food wastes in aqueous-natural deep eutectic solvent (A-NADES) with robust Al2O3 or Al(OH)3

Novel insights into CO 2 inhibition with additives in catalytic aerobic oxidation of biomass-derived carbohydrates to formic acid

Ultra-thin layer HTaMoO 6 catalyst for the upgrading of carbohydrates into 5-hydroxymethylfurfural

Conversion of biomass-derived carbohydrates into 5-hydroxymethylfurfural catalyzed by sulfonic acid-functionalized carbon material with high strong-acid density in γ-valerolactone

A remarkable bifunctional carbon-based solid acid catalyst derived from waste bio-tar for efficient synthesis of 5-hydroxymethylfurfural from glucose