Abstract:The efficacy of steady large-amplitude blowing/suction on instability and transition control for a hypersonic flat plate boundary layer with Mach number 5.86 is investigated systematically. The influence of the blowing/suction flux and amplitude on instability is examined through direct numerical simulation and resolvent analysis. When a relatively small flux is used, the two-dimensional instability critical frequency that distinguishes the promotion/suppression mode effect closely aligns with the synchronisation frequency. For the oblique wave, as the spanwise wavenumber increases, the suppression effects would become weaker and the mode suppression bandwidth diminishes/increases in general in the blowing/suction control. Increasing the blowing/suction flux can effectively broaden the frequency bandwidth of disturbance suppression. The influence of amplitude on disturbance suppression is weak in a scenario of constant flux. To gain a deeper insight into disturbance suppression mechanism, momentum potential theory (MPT) and kinetic energy budget analysis are further employed in analysing disturbance evolution with and without control. When the disturbance is suppressed, the blowing induces the transport of certain acoustic components along the compression wave out of the boundary layer, whereas the suction does not. The velocity fluctuations are derived from the momentum fluctuations of the MPT. Compared with the momentum fluctuations, the evolutions indicated by each component's velocity fluctuations greatly facilitate the investigations of the acoustic nature of the second mode. The rapid variation of disturbance amplitude near the blowing is caused by the oscillations of the acoustic component and phase speed differences between vortical and thermal components. Kinetic energy budget analysis is performed to address the non-parallel effect of the boundary layer introduced by blowing/suction, which tends to suppress disturbances near the blowing. Moreover, viscous effects leading to energy dissipation are identified to be stronger in regions where the boundary layer is rapidly thickening. Finally, it is demonstrated that a flat plate boundary layer transition triggered by a random disturbance can be delayed by a blowing/suction combination control. The resolvent analysis further demonstrates that disturbances with frequencies that dominate the early transition stage are dampened in the controlled base flow.

Stability analysis of roughness-disturbed boundary layer controlled by wall-blowing

Direct numerical simulation of roughness-induced transition controlled by two-dimensional wall blowing

Control of Roughness-Induced Transition under the Influence of Inflow Disturbance

Direct Numerical Simulations of First-Mode Oblique Breakdown in a Supersonic Boundary Layer under Wall Transpiration

Triadic Resonance Analysis of Distributed Roughness Effects on Crossflow Instability in Swept-Wing Boundary Layers

Roughness-Induced Transition in Supersonic Boundary Layers with Wall Heating and Cooling Effects

Experimental Investigation of Cross-Flow Instability in Swept-Wing Boundary Layers

Instability and Transition Control by Steady Local Blowing/suction in a Hypersonic Boundary Layer

Surface-Roughness Effects on Crossflow Instability of Swept-Wing Boundary Layers Through Generalized Resonances

Hypersonic Boundary-Layer Instability Characterization and Transition Downstream of Distributed Roughness

Experimental study of the effects of isolated roughness elements on the stability and transition of a hypersonic boundary layer on a flat plate

Effects of Distributed Roughness on Crossflow Instability through Generalized Resonance Mechanisms

Controlling Second-Mode Oblique Breakdown in High-Speed Boundary Layers Using Streak: A Direct Numerical Simulation Study

Transition Control Experiment Based on Linear Stability Theory

Three-dimensional Global Instability Analysis for High-Speed Boundary Layer Flow

Effects of Localized Micro-blowing on a Spatially Developing Flat Turbulent Boundary Layer

Control of First-Mode Oblique Breakdown in a Supersonic Boundary Layer Using Micro-Groove Coating Strips

Temporal Stability of A Particle-Laden Blasius Boundary Layer

Investigation on Cross-flow Instabilities in Swept-wing Boundary Layers with Linear Parabolized Stability Equations

A Combined Experimental and Numerical Investigation of Roughness Induced Supersonic Boundary Layer Transition

Stabilization of Hypersonic Boundary Layer by Combining Micro-Blowing and a Porous Coating