Abstract:For the numerical simulation of underwater wet flux-cored arc welding, the most crucial issue is to investigate the intense interactions between the underwater bubble, arc plasma, and molten metal. However, it is a great challenge to couple them into a single numerical model. In this study, a 3D three-phase flow model is originally established, which successfully couples the dynamic bubble, arc, and droplet. A modified Lee model is employed to realize spontaneous phase transition from liquid water to bubble gas. According to the simulation results, the bubble evolution is divided into four main stages, and two bubble separation modes are recognized. It is found that, both the changing pressure field around the bubble and the varying flow direction of surrounding water contribute to the unique bubble evolution patterns. As for the droplet, its violent up-and-down oscillation at the wire tip is mainly caused by the opposite gas drag forces, which are produced by the turbulent gas flow inside the bubbles. The upward gas drag force can even make the neck of the droplet disappear. With different droplet detaching angles, two predominant droplet transfer modes are numerically produced; when the angle reaches 147°, the droplet is pushed away and becomes a spatter. Furthermore, the underwater arc is found to be subjected to compressions from both the radial direction due to bubble necking and the axial direction due to droplet growth. The arc temperature and velocity vary significantly not only during the whole droplet transfer period, but also within each bubble evolution cycle. To verify the reliability of the model, underwater welding experiments and visual sensing are conducted. The simulated results match well with the experimental ones, with an 8% error in the droplet transfer period and only a 1.4% error in the bubble evolution cycle.

Macroscopic Simulation of Streamer Development in Mineral Oil

Simulation of Positive Streamers in Atmospheric Air by a Macroscopic Model with a New Branching Criterion

Research and Development on Short Gap Streamer Discharge Simulation Methods

Numerical Simulation on Streamer Discharge of Short Air Gap of Atmospheric Air

Experimental and 2D fluid simulation of a streamer discharge in air over a water surface

Simulation of the Streamer Propagation in the Transformer Oil with Bubbles

Numerical Model of Two-Phase Gas–Liquid Streamer Discharge in Ester-Based Insulating Oil Under Impulse Voltage

Numerical simulation of streamer evolution in surface dielectric barrier discharge with electrode-array

Macroscopic parameterization of positive streamer heads in air

Quantitative modeling of streamer discharge branching in air

3D fluid modeling of positive streamer discharges in air with stochastic photoionization

Adaptive Mesh Refinement and Embedded Boundary Method for Streamer Discharge Simulations

Numerical Simulation of Streamer Discharge with Different Electrode Shapes in C4F7N

Dynamic development model for long gap discharge streamer-leader system based on fractal theory

Self-Consistent Positive Streamer-Leader Propagation Model Based on Finite Element Method (FEM) and Voltage Distortion Method (VDM)

The Development of the Streamer Discharge to Flashover along the Dielectric Surfaces

The simulation of streamer dynamics in the air gap

Simulation of Positive Surface Discharge in C4F7N Gas Mixture

Discharge Characteristics and Numerical Simulation of the Oil–Gas Surface under DC Voltage

Modeling the coupled bubble-arc-droplet evolution in underwater flux-cored arc welding

A computational study of positive streamers interacting with dielectrics