Abstract:Shallow aquifer monitoring is likely to be a required aspect to any geologic CO2 sequestration operation. Collecting groundwater samples and analyzing for geochemical parameters such as pH, alkalinity, total dissolved carbon, and trace metals has been suggested by a number of authors as a possible strategy to detect CO2 leakage. The effectiveness of this approach, however, will depend on the hydrodynamics of the leak-induced CO2 plume and the spatial distribution of the monitoring wells relative to the origin of the leak. To our knowledge, the expected effectiveness of groundwater sampling to detect CO2 leakage has not yet been quantitatively assessed. In this study we query hundreds of simulations developed for the National Risk Assessment Project (US DOE) to estimate risks to drinking water resources associated with CO(2)leaks. The ensemble of simulations represent transient, 3-D multi-phase reactive transport of CO2 and brine leaked from a sequestration reservoir, via a leaky wellbore, into an unconfined aquifer. Key characteristics of the aquifer, including thickness, mean permeability, background hydraulic gradient, and geostatistical measures of aquifer heterogeneity, were all considered uncertain parameters. Complex temporally-varying CO2 and brine leak rate scenarios were simulated using a heuristic scheme with ten uncertain parameters. The simulations collectively predict the spatial and temporal evolution of CO2 and brine plumes over 200 years in a shallow aquifer under a wide range of leakage scenarios and aquifer characteristics.Using spatial data from an existing network of shallow drinking water wells in the Edwards Aquifer, TX, as one illustrative example, we calculated the likelihood of leakage detection by groundwater sampling. In this monitoring example, there are 128 wells available for sampling, with a density of about 2.6 wells per square kilometer. If the location of the leak is unknown a priori, a reasonable assumption in many cases, we found that the leak would be detected in at least one of the monitoring wells in less than 10% of the scenarios considered. This is because plume sizes are relatively small, and so the probability of detection decreases rapidly with distance from the leakage point. For example, 400m away from the leakage point there is less than 20% chance of detection.We then compared the effectiveness of groundwater quality sampling to shallow aquifer and/or reservoir pressure monitoring. For the Edwards Aquifer example, pressure monitoring in the same monitoring well network was found to be even less effective that groundwater quality monitoring. This is presumably due to the unconfined conditions and relatively high permeability, so pressure perturbations quickly dissipate. Although specific results may differ from site to site, this type of analysis should be useful to site operators and regulators when selecting leak detection strategies. Given the spatial characteristics of a proposed monitoring well network, probabilities of leakage detection can be rapidly calculated using this methodology.Although conditions such as these may not be favorable for leakage detection in shallow aquifers, leakage detection could be much more successful in the injection reservoir. We demonstrate proof-of-concept for this hypothesis, presenting a simulation where there is measurable pressure change at the injection well due to overpressurization, fault rupture, and consequent leakage up the fault into intermediate and shallow aquifers. The size of the detectible pressure change footprint is much larger in the reservoir than in either of the overlying aquifers. Further exploration of the range of conditions for which this technique would be successful is the topic of current study. (C) 2015 Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creavativecommons.org/licesses/by-nc-nd/3.0/). Peer-review under responsibility of the Organizing Committee of GLIGT-12

A Monitoring System for CO2-EOR and Storage Based on Reactive Transport Simulation of CO2 Migration in Groundwater

Influence of CO2 Migration from Geological Storage on the Chemical Composition of Groundwater and Monitoring Indicators

Optimizing a Monitoring Scheme for CO2 Geological Sequestration: an Environmentally Sustainable and Cost-Efficient Approach

Modeling CO2 migration in a site-specific shallow subsurface under complex hydrodynamics

Improving monitoring network design to detect leaks at hazardous facilities: Lessons from a CO2 storage site

Assessment of shallow aquifer remediation capacity under different groundwater management conditions in CGS field

Monitoring of CO2 Geological Storage Based on the Passive Surface Waves

Advancing CO2 Storage Monitoring Via Cross-Borehole Apparent Resistivity Imaging Simulation

Modeling of possible CO2 leakage with phase transition in wellbore-reservoir system based on the Ordos CCS project, China

Numerical Simulation of CO2 Leakage in a Shallow Subsurface Layer from a CO2 Geological Storage Site

Reactive transport modeling for CO2 geological sequestration

Monitoring Approaches for Detecting and Evaluating CO2 and Formation Water Leakages into Near-surface Aquifers

Looking for leakage or monitoring for public assurance?

Effective Detection of CO2 Leakage: a Comparison of Groundwater Sampling and Pressure Monitoring

Simple and effective atmospheric monitoring for CO2 leakage

CO2 capture and storage monitoring based on remote sensing techniques: A review

Safety Analysis of Geothermal Water Recharge Coupled with CO2 Geological Storage System

Fluid Sampling Monitoring at Yanchang CO2-EOR Demonstration Site, Ordos Basin, China

Online Monitoring of Geological ${\rm CO}_{2}$ Storage and Leakage Based on Wireless Sensor Networks

A Feasibility Study of CO2geologic Sequestration Integrating Reservoir Simulation, Rock-Physics Theory, and Seismic Modeling