Abstract:Poly( 3,4-ethylenedioxythiophene) ( PEDOT) is usually dispersed in water by incorporating polystyrene sulfonate ( PSS) as a charge compensator and a template for polymerization. The polymerization behavior of 3,4-ethylenedioxythiophene (EDOT) without assistance of insulating PSS was explored. Due to their semiconducting and hydrophilic characteristics, pi-conjugated polyelectrolytes with sulfonic acid groups, namely PCPDT-T and PCPDT-2T, were used as template for in situ oxidative polymerization of PEDOT. The obtained PEDOT: polyelectrolyte composites showed good dispersibility in aqueous solution, which was used as hole transport layer (HTL) in polymer solar cells (PSCs). The morphologies and photoelectric properties of PEDOT:PSS and PEDOT:polyelectrolyte composites were characterized by Fourier transform infrared spectroscopy, ultraviolet-visible spectroscopy, ultraviolet photoelectron spectroscopy, atomic force microscopy, transmission electron microscopy and contact angle test, respectively. PEDOT:polyelectrolyte composites displayed suitable energy level, transmittance up to 95% (30 nm), hydrophobic surface morphology, as well as superior hole mobility, which were in favour of forming Omega contact with the active layer and increasing the injection and collection efficiency of the holes. Thus, improving the device photovoltaic performance. The current density-voltage (J-V) characteristics of the PSCs with the structure of Glass/ITO/HTL/PTB7-Th:PC71BM/PFN/Al were measured under one standard sun by solar simulator with an Air Mass 1.5 global (AM 1.5G) and an irradiation intensity of 100 mW/cm(2). Compared to the photovoltaic characteristics for PEDOT:PSS based device, PSCs with PEDOT:T (1:2) as HTL yielded the highest power conversion efficiency (PCE) of 8.6% with a short current density (J(SC)) of 18.07 mA/cm(2), open circuit voltage (V-OC) of 0.77 and fill factor (FF) of 61.31%, respectively. Compared to that of PEDOT:PSS, the obvious increased J(SC) for PEDOT:polyelectrolyte composites based PSCs was ascribed to the high hole mobility and transmittance, which were consistent with the results from the space-charge limited current (SCLC) method and the external quantum efficiency (EQE) measurement.

Optimizing Conducting Polymer Top Electrodes for Nonfullerene Organic Solar Cells

Simple Solvent Treatment Enabled Improved PEDOT:PSS Performance Toward Highly Efficient Binary Organic Solar Cells

Enhancing Efficiency of Organic Solar Cells with Alkyl Diamines Doped PEDOT: PSS

Two-in-one alcohol-processed PEDOT electrodes produced by solvent exchange for organic solar cells

Exploring the Chemical Interaction Between Diiodooctane and PEDOT-PSS Electrode for Metal Electrode-Free Nonfullerene Organic Solar Cells.

A New PEDOT Derivative for Efficient Organic Solar Cell with a Fill Factor of 0.80

Boosting Performance of Non‐Fullerene Organic Solar Cells by 2D g‐C3N4 Doped PEDOT:PSS

PEDOT:PSS‐Metal Oxide Composite Electrode with Regulated Wettability and Work Function for High‐Performance Inverted Perovskite Solar Cells

Electron-Transporting Polymer with Perfluoroalkyl Spacer Enables Efficient and Stable Non-Fullerene Organic Solar Cells

Ultrafast-laser-treated poly(3,4-ethylenedioxythiophene): poly(styrenesulfonate) electrodes with enhanced conductivity and transparency for semitransparent perovskite solar cells

Sulfonate Poly(aryl Ether Sulfone)-Modified PEDOT:PSS As Hole Transport Layer and Transparent Electrode for High Performance Polymer Solar Cells

In situ Polymerization of PEDOT: pi-Conjugated Polyelectrolyte and Application as Hole Transport Layer in Polymer Solar Cells

Optimization of a Polymer Top Electrode for Inverted Semitransparent Organic Solar Cells

PEDOT:PSS‐Free Polymer Non‐Fullerene Polymer Solar Cells with Efficiency up to 18.60% Employing a Binary‐Solvent‐Chlorinated ITO Anode

Low Work-function Poly(3,4-ethylenedioxylenethiophene): Poly(styrene Sulfonate) As Electron-transport Layer for High-efficient and Stable Polymer Solar Cells.

Semiconductive Polymer-Doped PEDOT with High Work Function, Conductivity, Reversible Dispersion, and Application in Organic Solar Cells

A Nonionic Surfactant Simultaneously Enhancing Wetting Property and Electrical Conductivity of Pedot:Pss for Vacuum-Free Organic Solar Cells

Research Progress on Polymer Solar Cells Based on PEDOT:PSS Electrodes

Low‐Work‐Function PEDOT Formula as a Stable Interlayer and Cathode for Organic Solar Cells

Solution-Processed Transparent Conducting Electrodes for Flexible Organic Solar Cells with 16.61% Efficiency

Highly Efficient Organic Solar Cells Enabled by the Incorporation of a Sulfonated Graphene Doped PEDOT:PSS Interlayer