Abstract:C ONFIGURATIONS with a highly flexible delta wing are considered for the next generation of unmanned air vehicles (UAV). Delta wing flowfield is dominated by vortical structures at high angle of attack, the most prominent is called leading-edge vortex. Ye and Zhao [1] used a nonlinear lifting line method to compute the aerodynamic loads of the delta wing at high angle of attack. With the development of computer technology, computational fluid dynamics (CFD) technique has been used in the simulation of delta wing-induced vortical flow. The study [2] shows that the Reynolds number affects primary vortex slightly, and so Euler codes can be employed to simulate the vortex and aerodynamic loads; the shortness is that it cannot simulate the secondary vortex caused by the effect of viscosity. The CFD and computational structural dynamics (CSD) direct coupling method has been used in aeroelastic analysis of deltawing.Gordnier et al. [3,4] coupled Euler/ Navier–Stokes codes and nonlinear plant element to study the buffet problem of the flexible delta wing at high angle of attack. The CFD and CSD direct coupling method [5–7] has also been used in the nonlinear flutter simulation of delta wing at small angle of attack (<5 deg). The limitation of the direct aeroelastic simulation method is the high cost of the computational time. To solve the contradiction between computational efficiency and computational quality, many researchers turn to CFD-based unsteady aerodynamic reduced-order modeling (ROM) to improve the aeroelastic computational efficiency in the last decade. Dowell and Hall [8], Lucia et al. [9], and Zhang and Ye [10] present some overviews of ROM and its applications on nonlinear aeroelastic research. There are two kinds of methods for ROMof unsteady aerodynamic loads at the present time. The one is the proper orthogonal decomposition (POD) based reduced-order modeling method, the other is aerodynamic modeling based on structural modes by using identification technology. The second method is used in this work. Zhang [11] compared the efficiency between the ROM-based method and the CFD direct simulation method. Efficiency can be improved by 1 2 orders with accuracy still retained by ROM-based method. Zhang used CFDbased ROM to perform aeroservoelastic analysis [12] and transonic flutter suppression by active control [13].

Forced response analysis of the rotor blade rows with the ROM-based aeroelastic model

Static Aeroelasticity Analysis of a Rotor Blade Using a Gauss-Seidel Fluid-Structure Interaction Method

Low-Engine-Order Forced Response Analysis of a Turbine Stage with Damaged Stator Vane

Theoretical and Experimental Investigations on Steady-State Responses of Rotor-Blade Systems with Varying Rotating Speeds Based on a New Nonlinear Dynamic Model

A Developed Component Mode Synthesis for Parametric Response Analysis of Large-Scale Asymmetric Rotor

Response calculation method for the rotor blade with arbitrary rigid motions

Dynamic Response Analysis of the Blade of Horizontal Axis Wind Turbines

Helicopter Rotor-Fuselage Aeroelasticity Modeling and Solution Using the Partition-Iteration Method

Efficient Forced Response Minimization Using a Full-Viscosity Discrete Adjoint Harmonic Balance Method

The Mechanism Revealing and Law Explorating for the Nonlinear Response of Blade Disk Rotor System Under the Coupling Effects of Crack and Aerodynamic Force

Comparison among rotor blade structural load calculation methods

Numerical Simulation Method for the Aeroelasticity of Flexible Wind Turbine Blades under Standstill Conditions

Response Calculation Method for the Rotor Blade Based Upon Flexible Multibody Dynamics

Dynamical response analysis on blades arisen by aerodynamic forces through sequential method

A Reduced Order Model for Uncoupled and Coupled Cascade Flutter Analysis

Forced Response Analysis of Shrouded Blades by an Alternating Frequency/Time Domain Method

Dynamic Gust Load Analysis for Rotors

Rotor Vibratory Load Prediction Based on Generalized Forces

Dynamic Modeling and Vibration Characteristics for a High-Speed Aero-Engine Rotor with Blade Off

Reduced-Order-Model-Based Flutter Analysis at High Angle of Attack

NUMERICAL INVESTIGATIONS OF THE LONG BLADE PERFORMANCE USING RANS SOLUTION AND FEA METHOD COUPLED WITH ONE-WAY AND TWO-WAY FLUID-STRUCTURE INTERACTION MODELS