Abstract:Aluminum is a promising energy-containing material that can satisfy both aerospace and underwater thermodynamic propulsion systems. A high-temperature pressurized combustion chamber and a CO2 laser were adopted to investigate the ignition and combustion characteristics of 2, 5, and 40 μm aluminum particles in a 1.0 MPa air–H2O–Ar mixed atmosphere (with varying O2 and H2O concentrations). The combustion-promoting effect of the ammonium perchlorate-coated modification (namely, the AP@Al sample) was evaluated. The results show that Al melts and agglomerates into millimeter-sized droplets (covered with a gas-phase flame) after ignition, and its nonhomogeneous combustion is dominated by diffusion. The flame propagation is greatly enhanced by the AP combustion-promoting effect of oxygen/heat supply and particle dispersion, resulting in a significant decrease in the ignition delay time (t i, approximately 55–85%) and combustion time (t c, approximately 32–96%), whereas an extraordinary increase in the maximum combustion temperature (T max, approximately 170–224 K) and pressure changes (approximately 1.7–8.5 kPa, approximately 10.6–136.5 kPa/s) are also observed. Excess water vapor inhibits the flame propagation for AP@Al, viz. the flame area and number of ejected burning particles is decreased. The main factor affecting the combustion temperature is the oxidant rather than the particle size, which may be related to the small difference in the active aluminum content of the samples and the diffusion-controlled combustion mechanism. Due to the advantage of O2 for oxidation and the diffusion rate, the gradual replacement of H2O by air (similar to conversion to a fuel-lean system) leads to a decrease in t i, whereas T max is increased for all the samples, and the t c and self-sustaining combustion time are increased for the Al samples, whereas t c is decreased for AP@Al samples for both the equal-molar oxidizing gas concentration and equivalence ratio of O2–H2O control groups in this work. Since O2 creates a new pathway for AlO production, the ignition and combustion performance of Al and AP@Al samples is significantly improved when H2O is replaced by a small amount of air.

Effect of Α-Alh3 Content on Ignition and Combustion Characteristics of Multicomponent Mixtures

Thermal Oxidation and Heterogeneous Combustion of AlH3 and Al: A Comparative Study

Effect of AlH 3 on the Energy Performance and Combustion Agglomeration Characteristics of Solid Propellants

Enhanced stability and combustion performance of AlH3 in combination with commonly used oxidizers

Effect of Mass Ratio on Flame Propagation Behaviors and Thermal Radiation Performance of Al–AlH3 Composite Dust

Effects of AlH 3 particle size and loading on the combustion and agglomeration of solid propellants

Thermal Reaction and Combustion Mechanism of AlH3 with Different Particle Sizes

Combustion performance modulation and agglomeration inhibition of HTPB propellants by fine Al/oxidizers integration

Effect of pressure and oxygen content on the ignition and combustion of Al–Mg alloy

Ignition and combustion of Al and ammonium perchlorate-coated Al particles in a double oxidizing air–H2O–Ar atmosphere

Effects of TiAl3 addition on combustion synthesis of Ti3AlC

Effects of different Al contents on combustion synthesis of Ti3AlC2 powders in the Ti-Al-C system

Insights into the Fragmentation of Aluminum Hydride and Its Effect on Combustion and Agglomeration of HTPB Propellant

Effects of Oxidants on Combustion Performances of Al/H2O Based Fuels in Air

Effect of Particle Size and Oxygen Content on Ignition and Combustion of Aluminum Particles

Ignition and combustion properties of NGO coated AlH 3

The Effect of Li-Al Alloy on Combustion Performance of B/PTFE Fuel-Rich Propellant

Effects of carbon contents on combustion synthesis of Ti2AlC powders

The combustion mechanism of aluminium in the steam/carbon dioxide mixed atmosphere

EFFECTS OF TiAl ADDITION ON COMBUSTION SYNTHESIS OF Ti_2AlC

Combustion and Energy Performance of Multiple Aluminum-Based Alloy Particles