Microplastics Mitigation in Sewage Sludge through Pyrolysis: The Role of Pyrolysis Temperature
Bing-Jie Ni,Zhuo-Ran Zhu,Wei-Hua Li,Xiaofang Yan,Wei Wei,Qiuxiang Xu,Zhaohui Xia,Xiaohu Dai,Jing Sun
DOI: https://doi.org/10.1021/acs.estlett.0c00740
2020-09-22
Abstract:Sewage sludge is an important source of introducing microplastics into the environment, and thus, effective mitigation of microplastics in the sludge is in urgent need. Herein, the effect of pyrolysis on microplastics reduction in sewage sludge was investigated through a lab-scale study. The micro-Raman analysis showed that the microplastics concentrations in sludge residues decreased significantly from 550.8 to 960.9 particles/g to 1.4–2.3 particles/g with the pyrolysis temperature increasing to 500 °C, and no tiny (10–50 μm) microplastics remained. Polyethylene and polypropylene, the two most abundant microplastics in sewage sludge, were entirely degraded when the pyrolysis temperature reached 450 °C. However, during the pyrolysis process, new plastic polymers could be produced through the reaction between original microplastics with organics in sludge, and heavy metals in sludge can also be combined. Moreover, scanning electron microscopy analysis of spiked microplastics showed that incomplete pyrolysis at low temperatures could result in rough surface morphology of microplastics, making it more readily to adsorb contaminants. Overall, the results of this study provide the first insight into the effectiveness of microplastics control in sewage sludge through pyrolysis, but to avoid potential environmental risks induced by incomplete pyrolysis, a pyrolysis temperature of 450 °C should be reached at least.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.estlett.0c00740?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.estlett.0c00740</a>.Details of spiked sample processing (Paragraph S1), density separation process for microplastics extraction (Paragraph S2), peroxidation process to remove organic matter in sludge (Paragraph S3), and Raman spectroscopy process for microplastic identification (Paragraph S4). Main characteristics of the collected sludge (Table S1). Figures of microplastics characterization in untreated Sludge B and Sludge B samples pyrolyzed at different temperatures (Figure S1), Raman spectra references of PE, EVA, and EAA (Figure S2), Raman spectra and matching results of virgin PE particles and spiked PE particles pyrolyzed after 150, 350, and 450 °C (Figure S3), scanning electron images of untreated PE particle and pure PE particle after pyrolysis at 150, 350, and 450 °C (Figure S4), Raman spectra and matching results of pure PE particles after pyrolysis at 150, 350, and 450 °C (Figure S5), Raman spectra of virgin PP, PS, and PA particles, pyrolysis at 450 °C, copyrolysis with sludge at 450 °C (Figure S6), photographs of dried and ground sludge powder and sludge powder with spiked PE particles before and after pyrolysis at 450 °C (Figure S7). (<a class="ext-link" href="/doi/suppl/10.1021/acs.estlett.0c00740/suppl_file/ez0c00740_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.
environmental sciences,engineering, environmental