Abstract:Alloy 2060, a new generation of aluminum–lithium (Al-Li) alloy, is widely used for aviation structural parts due to its high-specific strength and high-specific stiffness. However, poor formability of Al-Li alloy is commonly exhibited at room temperature. In this paper, the formability of Al-Li alloy 2060 was studied under the conditions of elevated temperatures. The Marciniak–Kuczynski (M–K) model was developed to effectively predict the forming limit curves (FLCs) under hot stamping conditions. Firstly, the hot tensile test was conducted to investigate the high-temperature deformation behaviors, and the Fields–Backofen equation was calibrated to represent the flow stress of the alloy. Then, the isothermal hemispherical punch tests were proposed to obtain the FLCs of Al-Li alloy 2060. Finally, the FLC predicted by the M–K model was input into the deep drawing finite element simulation model to verify the accuracy of the prediction results and predict the possible fracture of the hot stamping parts. The cup-shaped deep drawing test and the thin-walled shell part hot stamping test were carried out to verify the accuracy of the FLCs and the formability of the Al-Li alloy 2060. The results show that the true stress increases with the strain rate increasing and decreases with the temperature increasing. The established M–K model can accurately predict the FLCs of alloy 2060. It is also found that the initial thickness imperfection factor f0 is an important parameter that determines the change of FLC. Comparing the experimental and simulation results, it is concluded that the established M–K model would be adaptable in the FE simulation to estimate if the fracture of parts occurs. The simulation model considered the FLC can predict the fracture, thinning, and wrinkle of the parts. The stamping depth increases with the deformation temperature increasing and the blank holder force decreasing.

Development of a Formability Prediction Model for Aluminium Sandwich Panels with Polyvinylidene Difluoride Core

Forming limit diagram prediction of AA5052/polyethylene/AA5052 sandwich sheets

Influence of interfacial adhesion strength on formability of AA5052/polyethylene/AA5052 sandwich sheet

Face sheet defects in plastic forming of aluminum foam sandwich panel: theoretical models, numerical and experimental studies

Multi-point forming of sandwich panels with egg-box-like cores and failure behaviors in forming process: Analytical models, numerical and experimental investigations

Feasibility evaluation of failure models for predicting forming limit of metal foils

Predicting Sheet Forming Limit of Aluminum Alloys for Cold and Warm Forming by Developing a Ductile Failure Criterion

Investigation of Forming Behaviour of Metal-Polymer Sandwich Composite through Limit Dome Height Test Simulations

Prediction of Fracture in Square-Cup Forming of Aluminium Alloy

Experimental and numerical study of thermoforming of Al/CFRP hybrid composites

Collapse Models of Aluminum Foam Sandwiches under Static Three-Point Bending Based on 3D Geometrical Reconstruction

M–K model based forming limit prediction of aluminum–lithium alloy 2060 and its application in hot stamping

A New Three-Dimensional Progressive Damage Model for Fiber-Reinforced Polymer Laminates and Its Applications to Large Open-Hole Panels

Three-point bending performances of integral-forming aluminum foam sandwich

Numerical prediction and experimental validation of forming limit curves of laminated half-hard aluminum sheets

Numerical and experimental investigations on the formability of three-dimensional aluminum alloy sandwich panels with egg-box-like cores

Damage failure prediction study of carbon fiber metal laminates in hot stamping process

Discrete element modeling of metal skinned sandwich composite panel subjected to uniform load

Overview on the Prediction Models for Sheet Metal Forming Failure: Necking and Ductile Fracture

Finite Element Analysis on Ultimate Strength of an Aluminum Alloy Sandwich Panel

Determination and Application of Forming Limit Diagram of Aluminium Alloy 5083 Sheet