Abstract:An in-situ reaction controlled non-solvent induced phase separation (RC-NIPS) method was developed to tailor the morphology of polyvinyl chloride (PVC)/styrene-maleic anhydride (SMA) grafting polyethylene glycol (PEG) (SMA-g-PEG) blend ultrafiltration (UF) membrane. Herein, PVC and SMA was dissolved in dimethylacetamide (DMAc) solvent to prepare a casting solution (16 wt.% polymer concentration) at 50 °C. Subsequently, PEG (20 kDa) as an additive and reactant was added to the casting solution at a mass ratio of PEG to the polymer 1/1 wt./wt. to enhance the hydrophilicity and mechanical elongation of the membrane. Results demonstrated that the casting solution with PVC/SMA = 3/1 wt./wt. was an entirely compatible system. The viscosity of the casting solution with adding PEG gradually increased from 692 mPa s to1880 mPa s at the initial stage and 4780 mPa s at 42 h, then rose sharply to 27,320 mPa s at 84 h. This behavior was ascribed to the esterification reaction between PEG and SMA, leading to pre-gelation and gelation of the system. Whereafter, SMA-g-PEG graft polymers were obtained. Meanwhile, the degree of grafting (DG) increased from 0.40% at 12 h of the reaction to 2.61% at 42 h. Afterwards, a phase inversion using water as coagulation was used to prepare PVC/SMA-g-PEG blend membrane after a certain time of the esterification reaction. It was found that the morphology of resultant membranes systematically changed from asymmetric structure with a dense top layer and finger-like sublayer at the initial stage to a dense layer with a fully sponge-like structure after 18–42 h reaction. The PVC/SMA-g-PEG membrane obtained after the reaction of 42 h demonstrated better hydrophilicity, high pure water permeance and excellent toughness due to the internal plasticization of water molecules. The membrane also exhibited a high BSA rejection (>95%) and fouling recovery rate (FRR) (85.9%). Our work provides some insights on tailoring the UF membrane structure and simultaneously enhancing permeability, antifouling performance and toughness.

Tailoring Nanofiltration Membrane Surface Using Modified Styrene-Maleic Anhydride for Water Purification

Construction of Nonfouling Nanofiltration Membrane Via Introducing Uniformly Tunable Zwitterionic Layer

Preparation and Characterization of Sulfated Carboxymethyl Cellulose Nanofiltration Membranes with Improved Water Permeability

Fabrication and Performance of a Low Operating Pressure Nanofiltration Poly(vinyl Chloride) Hollow Fiber Membrane

Improving the Performance of Polyamide Reverse Osmosis Membrane by Incorporation of Modified Multi-Walled Carbon Nanotubes

An Acid Resistant Nanofiltration Membrane Prepared from a Precursor of Poly(s-Triazine-amine) by Interfacial Polymerization

A NOVEL NANOFILTRATION MEMBRANE PREPARED WITH PAMAM AND TMC (I)

Preparation and Characterization of an Amphiphilic Polyamide Nanofiltration Membrane with Improved Antifouling Properties by Two-Step Surface Modification Method

Pore Size Tailoring from Ultrafiltration to Nanofiltration with PVC-g-PDMA Via Rapid Immersion Thermal Annealing

Modification of polysulfone ultrafiltration membrane by sequential deposition of cross-linked poly(vinyl alcohol) (PVA) and sodium carboxymethyl cellulose (CMCNa) for nanofiltration

Anti-Fouling Performance of Mixed Matrix PVDF Membranes with Mono-Hydroxyl Poly(dimethylsiloxane) (PDMS-OH) Grafted Silica Nanoparticles

Tailoring the micro-structure of PVC/SMA-g-PEG blend ultrafiltration membrane with simultaneously enhanced hydrophilicity and toughness by in situ reaction-controlled phase inversion

High-Performance Polyacrylic Acid-Grafted PVDF Nanofiltration Membrane with Good Antifouling Property for the Textile Industry

A Novel Positively Charged Nanofiltration Membrane Prepared from N,N-dimethylaminoethyl Methacrylate by Quaternization Cross-Linking

In Situ Chemical Modification with Zwitterionic Copolymers of Nanofiltration Membranes: Cure for the Trade-Off between Filtration and Antifouling Performance

Polyhydroxy Group Functionalized Zwitterion for a Polyamide Nanofiltration Membrane with High Water Permeation and Antifouling Performance

Tailoring Properties and Performance of Polyamide Composite Nanofiltration Membranes by LiCl-added Interfacial Polymerization

Fabrication of polyamide/zwitterion functionalized mesoporous silica nanofiltration membrane with highly enhanced antifouling performance

Tuning the microstructure of SMA / CPVC membrane for enhanced separation performance by adjusting the coagulation bath temperature

Synthesis and Characterization of a Thin-Film Composite Nanofiltration Membrane Based on Polyamide-Cellulose Acetate: Application for Water Purification

Preparation of polysulfone/sulfonated polysulfone-SiO 2 nanofiltration membrane and its performance characterization