Abstract:Ships that are navigating in ice covered waters are at risk of colliding with icebergs or ice floes, which can lead to severe damage to the ship's hull in certain conditions. Predicting these loads is of great importance for the design and safety of ships. Ice loads are driven by a range of parameters, including ice properties such as the compressive strength, the geometry of the ship's hull and values related to the interaction (e.g. impact velocity). Classification rules and requirements for polar vessels account for these parameters to a certain extent. However, sea ice exhibits not only variability of its properties but also the geometry of the ice shows a high degree of diversity: icebergs and ice floes exist in multiple different shapes. Therefore, this paper addresses the ice-structure interaction process, focusing on the influence of the initial ice contact shape and its impact on the local load. Additionally, the paper explores the feasibility of pinpointing geometric parameters of the ice responsible for influencing these loads. Ultimately, understanding which ice shape in contact poses the greatest risk would be valuable for improving numerical simulations for the worst case scenario and, consequently, enhancing the safety of ships in ice-prone environments. To achieve this, a comprehensive drop tower test campaign on a small-scale has been conducted at the test facilities of the Hamburg University of Technology. In these experiments, single impacts of differently shaped ice specimens against a rigid 50 mm steel plate in normal direction were investigated. In the experiments, a drop hammer was released from a predefined drop height to realize a brittle failure of the ice at an interaction velocity of about 2000 mm/s. This falls within the lower range of ship-ice interaction speeds. The drop hammer fell onto the ice specimen which was positioned centered underneath the drop hammer. The investigated specimen geometries were cylindrical shapes of 200 mm diameter with varying caps of cone, dome, wedge, ellipse and other shapes. Overall, 27 different shaped ice specimens were tested. The analysis includes the failure behavior of the ice specimens and the load introduced by the specific contact shapes. Two main failure modes were observed depending on the ice geometry, which showed significant differences in the load magnitude. Further relations between the initial contact area, the cone angle, and the specimen length to the peak force, maximum pressure, and energy were identified.

Eliminating the Influence of Measuring Point Failure in Ice Load Identification of Polar Ship Structures

Statistical Analysis of Ice Load on Icebreaker Ship Based on Stochastic Ice Fields

Experimental Investigation of Ice Loads on Structures during Quasi-Static Compression Tests

Full-scale Identification of Ice Load on Ship Hull by Least Square Support Vector Machine Method

Identification of ice loads on shell structure of ice-going vessel with Green kernel and regularization method

Far-field identification of ice loads on ship structures by radial basis function neural network

A quantitative method for the analysis of ship collision risk using AIS data

Investigating Load Calculation for Broken Ice and Cylindrical Structures Using the Discrete Element Method

Research on ship-ice collision model and ship-bow fatigue failure mechanism based on elastic-plastic ice constitutive relation

DATA ANALYSIS OF SHIPBORNE EM31-ICE MEASURING IN THE FOURTH CHINESE NATIONAL ARCTIC RESEARCH EXPEDITION

Influence of the ice shape on ice-structure impact loads

A CFD-DEM-FEM coupling method for the ice-induced fatigue damage assessment of ships in brash ice channels

Experimental-analytical method for determining the global ice load from ice compression on ships and floating platforms used as polar drifting observatories

Investigation of ice wedge bearing capacity based on an anisotropic beam analogy

A New Plastic Design Approach for the Vertical-Side-Plating Thickness of Ice-Strengthened Ships Suffering from Ice Floe Impacts

A Framework for Structural Analysis of Icebreakers during Ramming of First-Year Ice Ridges

Simulation of Abrasion Characteristics of Polar Ship Seawater Pipelines under the Coupling of Ice Particles and Vibration

Numerical Simulation of the Flowing of Ice Slurry in Seawater Pipe of Polar Ships

Study on de-icing criterion of anti-icing coating and simulation analysis method of mechanical de-icing process for polar ship superstructure

Research on Polar Operational Limit Assessment Risk Indexing System for Ships Operating in Seasonal Sea-Ice Covered Waters

Validating Material Models and Yield Criteria for Prediction of Impact Pressure