Time–frequency Characteristics of Noise Generated from Different Slat and Flap Geometrical Configurations of the High-Lift Device

Ling Li,Peiqing Liu,Hao Guo
DOI: https://doi.org/10.1016/j.apacoust.2022.108891
IF: 3.614
2022-01-01
Applied Acoustics
Abstract:High-lift device installed on modern large aircraft is a major noise source during the approach and land-ing phases. For high-lift device, slat and flap parameters such as gap, overlap and deflection angle have strong effect on aerodynamic and aeroacoustic characteristics. However, the research about time-fre-quency characteristics of high-lift device noise affected by slat and flap parameters is lacking. This paper presents an investigation on 30P30N model to reveal the effect of different slat and flap geometrical con-figurations on the aeroacoustic time-frequency characteristics with experimental measurement and wavelet analysis. The results show that the multiple tones at small flap and slat deflection angles are mainly generated from the flap gap region. The time-frequency characteristic of the tones is satisfied with the amplitude modulation phenomenon, namely that the acoustic energy concentrates on the pri-mary tone and the other tones are generated from the modulation process of the primary tone. While the multiple tones at large slat deflection angles are generated from the slat cove and slat gap regions. The time-frequency characteristic of the tones is satisfied with the mode switching phenomenon, namely that the dominant noise energy temporally switches from one mode to another in time and these mul-tiple tones cannot coexist independent of one another. (c) 2022 Elsevier Ltd. All rights reserved.
What problem does this paper attempt to address?