Abstract:The development of nanocomposite photocatalysts with high photocatalytic activity, cost-effectiveness, a simple preparation process, and scalability for practical applications is of great interest. In this study, nanocomposites of TiO2 Degussa P25 nanoparticles/activated carbon (TiO2/AC) were prepared at various mass ratios of (4:1), (3:2), (2:3), and (1:4) by a facile process involving manual mechanical pounding, ultrasonic-assisted mixing in an ethanol solution, paper filtration, and mild thermal annealing. The characterization methods included XRD, SEM-EDS, Raman, FTIR, XPS, and UV-Vis spectroscopies. The effects of TiO2/AC mass ratios on the structural, morphological, and photocatalytic properties were systematically studied in comparison with bare TiO2 and bare AC. TiO2 nanoparticles exhibited dominant anatase and minor rutile phases and a crystallite size of approximately 21 nm, while AC had XRD peaks of graphite and carbon and a crystallite size of 49 nm. The composites exhibited tight decoration of TiO2 nanoparticles on micron-/submicron AC particles, and uniform TiO2/AC composites were obtained, as evidenced by the uniform distribution of Ti, O, and C in an EDS mapping. Moreover, Raman spectra show the typical vibration modes of anatase TiO2 (e.g., E1g(1), B1g(1), Eg(3)) and carbon materials with D and G bands. The TiO2/AC with (4:1), (3:2), and (2:3) possessed higher reaction rate constants (k) in photocatalytic degradation of methylene blue (MB) than that of either TiO2 or AC. Among the investigated materials, TiO2/AC = 4:1 achieved the highest photocatalytic activity with a high k of 55.2 × 10−3 min−1 and an MB removal efficiency of 96.6% after 30 min of treatment under UV-Vis irradiation (120 mW/cm2). The enhanced photocatalytic activity for TiO2/AC is due to the synergistic effect of the high adsorption capability of AC and the high photocatalytic activity of TiO2. Furthermore, TiO2/AC promotes the separation of photoexcited electron/hole (e−/h+) pairs to reduce their recombination rate and thus enhance photocatalytic activity. The optimal TiO2/AC composite with a mass ratio of 4/1 is suggested for treating industrial or household wastewater with organic pollutants.

Surfactant-assisted Synthesis of Mo-doped TiO2/FAC (fly Ash Cenosphere) for Degradation of Methylene Blue Dye under Visible Light Irradiation

Preparation and Photocatalytic Properties of Mo-Doped TiO<sub>2</sub>@Fly Ash Cenospheres for Degradation of Methylene Blue

Fe-Doped Tio2/Sio2 Aerogel Microspheres for Visible Light Photocatalysis Degradation of Methylene Blue

Photocatalyst-coated Carbon Microtube Electrodes: Preparation and Characterization of Their Properties and Photocatalytic Degradation of Methylene Blue.

Photocatalytic Activity of TiO2/SiO2 Aerogels for Degradation Reaction of Methylene Blue

Carbon/Mn3O4/SrTiO3 Microsphere Photocatalyst for the Efficient Removal of High-Concentration Methylene Blue from Water

Visible light induced photocatalytic degradation of methylene blue using carbon fibre cloth - Bismuth oxybromide - Water hyacinth derived silver nanocomposite

Photoelectrocatalytic degradation of methylene blue using F doped TiO2 photoelectrode under visible light irradiation

photocatalytic degradation of TiO2 via incorporating Ti3C2 MXene for methylene blue removal from water

Methylene Blue Dye Photocatalytic Degradation over Synthesised Fe3O4/AC/TiO2 Nano-Catalyst: Degradation and Reusability Studies

Photocatalytic activity of Pt–TiO 2 films supported on hydroxylated fly ash cenospheres under visible light

Ag<sub>2</sub>O and NiO Decorated CuFe<sub>2</sub>O<sub>4</sub> with Enhanced Photocatalytic Performance to Improve the Degradation Efficiency of Methylene Blue

Ag2O and NiO Decorated CuFe2O4 with Enhanced Photocatalytic Performance to Improve the Degradation Efficiency of Methylene Blue

Efficient catalytic degradation of methylene blue by a novel Fe3+-TiO2@CGS three-dimensional photoelectric system

Integrated Nanostructures of TiO2/g-C3N4/Diatomite Based on Low-Grade Diatomite as Efficient Catalyst for Photocatalytic Degradation of Methylene Blue: Performance and Mechanism

A Novel Octamolybdate‐based Organic–inorganic Hybrid As Photo‐fenton‐like Catalyst for Degradation of Methylene Blue

Enhanced visible light photocatalytic degradation of methylene blue by F-doped TiO 2

Enhanced visible-light catalytic degradation of methylene blue by improving adsorption of porous zirconium-based porphyrin MOFs sensitized TiO2 photocatalyst

Efficient photocatalysis of Cu doped TiO2/g-C3N4 for the photodegradation of methylene blue

Facile synthesis of TiO2-carbon composite doped nitrogen for efficient photodegradation of noxious methylene blue dye

Facile Preparation Method of TiO2/Activated Carbon for Photocatalytic Degradation of Methylene Blue