Flow patterns of Rayleigh-Benard convection in cold water at maximum density in vertical cylindrical containers under conducting sidewall conditions

Xiaoran Ma,Yourong Li,Sen Yao,Yong Chen

DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2022.123122

IF: 5.2

2022-01-01

International Journal of Heat and Mass Transfer

Abstract:To understand the effects of aspect ratio and density inversion parameters on the critical conditions at the onset of convection in vertical cylindrical containers with perfectly-conducting side walls, a series of linear stability analyses (LSA) and three-dimensional numerical simulations were performed. The working fluid was cold water at maximum density and Prandtl number at similar to 11.57. Results indicated that, with increased aspect ratio (A, ratio of radius to height), the critical Rayleigh number (Ra-cri) was reduced and the number of convective rolls was more at a higher A than that at a lower one. The effects of A and density inversion (Theta(m)=(T-m-T-c)/(T-h-T-c)) were discussed in detail. The Theta(m) had a dramatic influence on the Ra-cri as well as flow structure at the primary threshold. With increased Theta(m), Ra-cri, sharply increased at higher values. Moreover, flow motion was only occurred near the bottom wall and a motionless fluid layer was found near the top wall, which were quite different from the fact that flow motion would occur in the whole container in a Boussinesq fluid. The depth of the convective fluid layer was thinner at a higher Theta(m). Notably, more convective rolls were found in the Z-direction at high Theta(m) due to fluid viscosity. Ra(cri )obtained by LSA were satisfyingly consistent with those by three-dimensional numerical simulations. (C) 2022 Elsevier Ltd. All rights reserved.