Abstract:Water pollution caused by the excessive growth of blue-green algae has become a growing environmental problem. One current approach to reducing the algae in Taihu Lake is to refloat the algae after a bloom has occurred. It can remove nitrogen and phosphorus in the lake simultaneously. The amount of algae-laden water collected from Taihu Lake can be up to approximately several thousand tons in wet weight per day. And they needs timely and effective treatment. The algae can be effectively degraded and produced into methane by anaerobic fermentation technology. The algae is easy to float and crust in the reactor, thus affecting the efficiency of the gas production and reducing the processing effect of the reactor. In anaerobic reactors, proper stirring can prevent algae floating and facilitate contact between the algae and other microbes, thereby improving gas production efficiency. This paper designed experimental device for optimizing the stirring of blue-green algae anaerobic fermentation. The device was made of double transparent glass with a working volume of 3 L. The device was equipped with an adjustable speed motor, which control the stirring interval, stirring duration and stirring cycle. Response surface methodology (RSM) was employed to optimize the stirring conditions. Simultaneously, the pilot study was adopted to provide a support of the best stirring condition of blue-green algae anaerobic fermentation. In the pilot study, protease content was assayed to characterize hydrolysis activity, TTC-dehydrogenase content was measured to characterize microbial enzyme activity, and coenzyme F420 content showed the activity of methanogenic anaerobes. The experimental results showed that the algae anaerobic fermentation was influenced by stirring interval, stirring duration, and stirring cycle. The correlation coefficient of the RSM regression equation was 0.98. RSM revealed the optimized stirring parameters for algae anaerobic fermentation as follows:Stirring intensity 56 r/min, stirring duration 20 min, and stirring cycle 6 h. Under these conditions, the proportional rates of gas and methane production in the pilot study were maximized at 0.39 and 0.236 L/(g·d), respectively. It was demonstrated that RSM methodology could be applied to the stirring process in larger-scale algae anaerobic fermentation reactors. Levels of protease, dehydrogenase, and coenzyme F420 were higher in optimized stirring parameters than other conditions. Stirring intensity was the main factor affecting biogas production by anaerobically fermenting algae. Stirring cycle exerted a secondary effect, while the effect of stirring duration was minor. Excessively intense and frequent stirring destroy the micro-environment of anaerobic microbial growth, partially disrupting the synergy between different anaerobic species. Conversely, an excessively weak stirring or prolonged stirring cycle lead to float of algae in the reactor, forming an upper algal layer. And the algal layer hinder the discharge of gas from the reactor. Meanwhile, less effective contact between algae and the microbes leads to the decrease of algae degradation rate.

A Smart and Precise Mixing Strategy for Efficient and Cost-Effective Microalgae Production in Open Ponds

Microalgal Wastewater Recycling: Suitability of Harvesting Methods and Influence on Growth Mechanisms

A promising microalgal wastewater cyclic cultivation technology: Dynamic simulations, economic viability, and environmental suitability

Characteristics and Performances of Microalgal-Bacterial Consortia in a Mixture of Raw Piggery Digestate and Anoxic Aerated Effluent

Improving the Efficiency of Wastewater Treatment and Microalgae Production for Biofuels

Exploiting mixotrophy for improving productivities of biomass and co-products of microalgae

Enhanced Production of Microalgal Metabolites Through Aeration Coupled with Stirring

Enhancement of Biomass Productivity and Nutrients Removal from Pretreated Piggery Wastewater by Mixotrophic Cultivation of Desmodesmus Sp Chx1

Numerical Study on the Internal Fluid Mixing and Its Influencing Mechanisms of the Wave-Driven Floating Photobioreactor for Microalgae Production

Forced Light/dark Circulation Operation of Open Pond for Microalgae Cultivation

Optimizing microalgal productivity in raceway ponds through a controlled mixing device

Sustainable development of microalgal biotechnology in coastal zone for aquaculture and food

Optimization of mechanical stirring technology in anaerobic fermentation treating algae and pilot trial validation

A Fungal Immobilization Technique for Efficient Harvesting of Oleaginous Microalgae: Key Parameter Optimization, Mechanism Exploration and Spent Medium Recycling.

Attached Cultivation Technology of Microalgae for Efficient Biomass Feedstock Production.

Optimization of culture condition for biodiesel production by Chlorella pyrenoidosa grown in municipal wastewater in open raceway ponds

Maximizing Productivity and Reducing Environmental Impacts of Full-Scale Algal Production through Optimization of Open Pond Depth and Hydraulic Retention Time

Optimization of Biomass Production and Nutrients Removal by Spirulina Platensis from Municipal Wastewater

Hydrodynamic Sloshing of Microalgae in Membrane Type Photobioreactor

Microalgae Cultivation Using an Aquaculture Wastewater As Growth Medium for Biomass and Biofuel Production.

Enhanced growth and auto-flocculation of Scenedesmus quadricauda in anaerobic digestate using high light intensity and nanosilica: A biomineralization-inspired strategy