Abstract:Monitoring two-phase cooling systems and identifying corresponding boiling regimes are vital to avoid device failure owing to thermal runaway. Boiling acoustic characteristics can be used to develop a nonintrusive monitoring tool because of its close relation to the bubble behavior. Compared with bubble image-based techniques, acoustic sensing is cheaper and easier to implement. However, the acoustic data available is very limited, especially for flow boiling. Also, real-time strategies are still lacking since the prediction models based on boiling acoustics are usually offline. Additionally, noise interference typically degrades model prediction performance. To promote the implementation of an automated boiling system amidst these challenges, we present a deep learning framework for real-time identification of boiling regimes using acoustic signals of flow boiling. Flow boiling experiments are first performed using HFE7100 under different conditions and then combined with deionized water data from our previous experiments to construct the acoustic dataset. We use the corresponding acoustic spectrograms to train and test a convolutional neural network which shows a prediction accuracy of 99.97 % without noise interference. A transfer learning strategy is further employed to improve the original model performance under noise interference. Finally, we add a decision logic to adapt the CNN model to acoustic data streams for real-time identification of boiling regimes. The CNN model with the decision logic can accurately identify the boiling regimes in real-time by scanning the corresponding spectrograms irrespective of working fluids and conditions. In practice, our strategy can be utilized to initiate the necessary precautions to avoid overheating-induced failure.

Deep Learning Based Closed-loop Identification of Typical Thermal Process Model

The Parameter Identification Method of Steam Turbine Nonlinear Servo System Based on Artificial Neural Network

Closed-loop Step Response Identification of Integrating and Unstable Processes

Fault Identification for a Closed-Loop Control System Based on an Improved Deep Neural Network

Dynamic learning of flue gas desulfurization process using deep LSTMs neural network

Two-stream Convolutional Neural Network for Non-Destructive Subsurface Defect Detection Via Similarity Comparison of Lock-in Thermography Signals

Image-based Process Monitoring Using Deep Learning Framework

A new closed-loop identification based on relay feedback

Thermal neural networks: Lumped-parameter thermal modeling with state-space machine learning

Twin-layer Online Identification of Thermal Systems

Establishing Convolutional Neural Network Kalman Recurrent Variational Autoencoder Using Infrared Imaging for Process Monitoring: An Application in Spinning Disk Processes

Identification of low-order unstable process model from closed-loop step test

Data-driven temperature estimation of non-contact solids using deep-learning re duce d-order models

Deep-learning modeling and control optimization framework for intelligent thermal power plants: A practice on superheated steam temperature

Nonintrusive identification of boiling regimes enabled by deep learning based on flow boiling acoustics

Identification of Low-Order Process Model with Time Delay from Closed-Loop Step Test.

High-temperature power reduction state identification for wind turbines using feature correlation analysis and deep learning methods

Research and Simulation of Boiler Combustion System Based on Convolution Neural Network

Identification of time delay model for integrating processes from closed-loop step test

Fuzzy and Neural Network Method of Identification for Closed-Loop and Non-Linear Object

Real-time power prediction approach for turbine using deep learning techniques