Abstract:A full understanding of the material properties of skin tissue is crucial for exploring its tribo-mechanical behaviour. It has been widely accepted that the mechanical behaviour of skin tissue for both small and large deformations can be accurately described using a hyperelastic model, such as the one developed by Ogden. However, obtaining these Ogden parameters for in-vivo skin by in-vivo experiments no matter the indentation or suction tests is a significant challenge. The mathematical model used to describe the material behaviour during the test should consider not only the material nonlinearity but also the geometrical confinement of the tissue, the large deformations induced, and the fact that the specimens are relatively thin. A range of contact models is available to describe the contact behaviour during the indentation test. However, none of them can be used for hyperelastic materials with small thickness under large deformations. Simultaneously explaining material nonlinearity and geometric nonlinearity, either through theoretical equations or numerical calculations, poses a significant challenge. In this research, we propose a pragmatic method to obtain Ogden parameters for in-vivo skin tissue by combining experimental indentation results and numerical simulations. The indentation tests were used to obtain the force-indentation depth curves, while the numerical simulations were used to obtain the strain fields. The method assumes the material behaviour of specimens can be linearized in each small deformation increment, and the contact model developed by Hayes can be applied to accommodate each increment. Then, the linear elastic behaviour in each increment can be described by the elastic modulus E which were obtained using Hayes model, and the principal stresses in each increment were subsequently obtained using Hooke's law. By combining all stress fields, overall stress-strain curves can be constructed, from which the hyperelastic Ogden parameters can be obtained. A second numerical simulation of the hyperelastic indentation was then performed using the obtained Ogden parameters, allowing a comparison of the experimental and simulated relationships between force and indentation.

A Method for Determining Elastic Constants and Boundary Conditions of Three-Dimensional Hyperelastic Materials

A FEM-based Direct Method for Identification of Young’s Modulus and Boundary Conditions in Three-Dimensional Linear Elasticity from Local Observation

A Multiple-Data-based Direct Method for Inverse Problem in Three-Dimensional Linear Elasticity

A Direct Method to Identify Young’s Moduli and Boundary Conditions of the Heterogeneous Material

A direct method to identify Young's moduli and boundary conditions of the heterogeneous material

A Novel Objective Function for the Inverse Problem of Simultaneous Identification of Unknown Youngs Modulus and Boundary Conditions with Noisy and Partial Observation

An Inverse Model and Mathematical Solution for Inferring Viscoelastic Properties and Dynamic Deformations of Heterogeneous Structures

Identification of elastic orthotropic material parameters by the scaled boundary finite element method

An inverse method of fundamental solutions for the identification of 2D elastic properties of anisotropic solids

A gradient based numerical algorithm to solve inverse dynamic viscoelastic problems of multi-variable identification

Assessing the Mechanical Properties of Anisotropic Soft Tissues Using Guided Wave Elastography: Inverse Method and Numerical Experiments

Robust Multiscale Identification of Apparent Elastic Properties at Mesoscale for Random Heterogeneous Materials with Multiscale Field Measurements

Simultaneous estimation of boundary conditions and material model parameters

Method of fundamental solutions for a three-dimensional inverse problem in linear elasticity

Hyperelastic constitutive model parameters identification using optical-based techniques and hybrid optimisation

A Non-Iterative Methodology to Reconstruct Boundary Shapes and Conditions in Isotropic Linear Elasticity Based on the BEM

A New Method for Determining the Ogden Parameters of Soft Materials using Indentation Experiments

Second order Method for Solving 3D Elasticity Equations with Complex and Sharp Interfaces

A Method to Solve the Inverse Problem in Ultrasound Elastography

Differentiable Neural-Integrated Meshfree Method for Forward and Inverse Modeling of Finite Strain Hyperelasticity

Machine-learning-based virtual fields method: Application to anisotropic hyperelasticity