A 5.12-Ghz LC-based Phase-Locked Loop for Silicon Pixel Readouts of High-Energy Physics

Li Xiao-Ting,Wei,Zhang Ying,Yan Xiong-Bo,Jiang Xiao-Shan,Yang Ping
DOI: https://doi.org/10.1007/s41365-022-01074-2
2022-01-01
Nuclear Science and Techniques
Abstract:There is an urgent need for high-quality and high-frequency clock generators for high-energy physics experiments. The transmission data rate exceeds 10 Gbps for a single channel in future readout electronics of silicon pixel detectors. Others, such as time measurement detectors, require a high time resolution based on the time-to-digital readout architecture. A phase-locked loop (PLL) is an essential and broadly used circuit in these applications. This study presents an application-specific integrated circuit of a low-jitter, low-power LC-tank that is PLL fabricated using 55-nm CMOS technology. It includes a 3rd-order frequency synthesis loop with a programmable bandwidth, a divide-by-2 pre-scaler, standard low-voltage differential signaling interfaces, and a current mode logic (CML) driver for clock transmissions. All the d-flip-flop dividers and phase-frequency detectors are protected from single-event upsets using the triple modular redundancy technique. The proposed VCO uses low-pass filters to suppress the noise from bias circuits. The tested LC-PLL covers a frequency locking range between 4.74 GHz and 5.92 GHz with two sub-bands. The jitter measurements of the frequency-halved clock (2.56 GHz) are less than 460 fs and 0.8 ps for the random and deterministic jitters, respectively, and a total of 7.5 ps peak-to-peak with a bit error rate of 10(-12). The random and total jitter values for frequencies of 426 MHz and 20 MHz are less than 1.8 ps and 65 ps, respectively. The LC-PLL consumed 27 mW for the core and 73.8 mW in total. The measured results nearly coincided with the simulations and validated the analyses and tests.
What problem does this paper attempt to address?