Abstract:Recently mode multiplexers and demultiplexers (MMUX/MDEMUX) based on photonic lantern (PL) techniques for few-mode fiber transmission have attracted great interest. However, the design of PLs with high modal selectivity has become a great challenge for weakly-coupled mode-division-multiplexing (MDM) applications. In this paper, we propose a highly mode-selective PL-MMUX/MDEMUX design for intensity-modulation/direct-detection MDM transmission adopting each non-degenerate mode or each pair of degenerate modes as an independent channel. For the PL-MMUX, differential-phase injection (DPI) scheme is adopted for each pair of degenerate modes and a corresponding low-modal-crosstalk dissimilar core arrangement method is proposed considering the interleaving positive and negative phase characteristics of modal lobes of degenerate linearly-polarized (LP) modes, which achieve very high modal selectivity. For the PL-MDEMUX, simultaneous reception of degenerate modes is achieved by combining the optical power of both degenerated modes utilizing non-mode-selective PLs. Numerical simulations for a 6-LP-mode PL-MMUX/MDEMUX are performed. Results show that the PL-MMUX with DPI scheme and proposed cores distribution achieve much lower modal crosstalk than other cores distributions and the overall modal crosstalk of the PL-MMUX and MDEMUX in back-to-back case is lower than -20.63 dB over the C-band for all modes. The tolerance of our design to imperfect fabrication of differentiator or environmental impact are also discussed. The proposed DPI and dissimilar core arrangement method have high expansibility and provide a new way for the design of highly selective PLs and are beneficial to the practical applications of weakly-coupled MDM transmission systems and networks.

Detection Method of Mode Power Based on Photonic Lantern

Optimization of Few-Mode-Fiber Based Mode Converter for Mode Division Multiplexing Transmission

A Wavelength-Insensitive All-Silicon In-Line Optical Power Monitor for Multimode Silicon Photonics

The Simulation of Mode Control for a Photonic Lantern Adaptive Amplifier

Mode-Dependent Loss Equalized Few-Mode Fiber Photonic Lantern

Research on Mode Hopping Detection of Ultra-narrow Line-width Lasers Based on the Visibility Change of Fiber Mach-Zehnder Interferometer

Mode Couplers and Converters Based on Dual-Core Hollow-Core Photonic Bandgap Fiber

A High-selectivity Photonic Lantern Demultiplexer for Weakly-coupled Mode Group Demultiplexing over MMF

Design of Self-Matching Photonic Lantern for High-Order Transverse-Mode Laser Systems

Investigation on Characteristics of Mode Hopping in Ultra-Narrow Linewidth Erbium-Doped Fiber Ring Laser under Pump Modulation

All-Optical Wavelength Conversion for Mode-Division Multiplexing Signals Using Four-Wave Mixing in A Dual-Mode Fiber

Design of Silicon Photonic Wavelength Conversion Chip for Mode-division Multiplexing Signals

Low-Loss All-Fiber Mode Multiplexers for Weakly-Coupled 4-Mode Fiber

Realizing a kilowatt-level fiber amplifier with a 42 μm core diameter fiber for improved multi-mode performance towards single mode operation output through adaptive spatial mode control utilizing a 3×1 photonic lantern

Mode-hopping Suppression of External Cavity Diode Laser by Mode Matching

Single- and dual-wavelength fiber laser with multi-transverse modes

Synthetic photonic lantern characterization and power regulation with intensity superposition mode decomposition

A simplified mode diversity coherent receiver based on non-mode-selective photonic lantern and Kramers-Kronig detection

A Study of Power Distributions in Photonic Lantern for Coherent Optical Receiver

Design of a Highly Mode-Selective Photonic Lantern for IM/DD MDM Transmission

Fiber Bragg grating sensing multiplexing method using photonic lantern spatial mode diversity