Abstract:Two-phase flow boiling in heat sinks and cold plates is attractive for various thermal management applications due to high effective heat capacity rates and high heat transfer coefficients compared to single-phase operation. In addition, multi-physics topology optimization is sought for generation of high performance thermal management components. Yet, the design of heat sinks using topology optimization has been restricted to single-phase flow physics, due to incompatibility between available two-phase flow models and traditional single-phase topology optimization approaches. Interface-capturing two-phase flow models are too computationally expensive for optimization; mixture and two-fluid models that treat the liquid and vapor phases as an interpenetrating continuum with interfacial transport phenomena captured through empirical correlations are computationally tractable for heat-sink-scale optimization. However, the penalization approaches commonly used to define the structures formed during topology optimization results in arbitrary fin and channel geometries for which a universal two-phase flow correlation is not available. To enable coupling with two-phase mixture models, this work leverages a homogenization approach to topology optimization wherein heat sink designs are represented using spatially varying microstructures with optimized dimensions. A predefined microstructure geometry is chosen for which two-phase flow correlations exist and therefore topology optimization can be performed. This work is the first to develop a topology optimization algorithm using a mixture model for simulating two-phase flow boiling to design heat sinks and cold plates. Part 1 of this study develops and implements the algorithm to investigate topology optimized heat sinks at various heat inputs, topology optimization grid sizes, and maximum vapor quality constraints. Topology optimized heat sinks designed for single-phase versus two-phase flow are compared. There are significant differences in hydraulic and thermal responses of the single-phase and two-phase designs due to high effective heat capacity rates and high heat transfer coefficients of flow boiling. A companion paper (Part 2) focuses on manufacturing, model calibration, and experimental validation of the topology optimized heat sinks under two-phase flow boiling. The algorithm demonstrated in this work extends the capabilities of topology optimization to two-phase flow physics, and thereby enables the design of various two-phase flow components such as evaporators, condensers, heat sinks, and cold plates.

Derivation of a continuous adjoint topology optimization method applied on heat transfer for incompressible flow

Aerodynamic Design Optimization by Using a Continuous Adjoint Method

Adjoint Aerodynamic Optimization of a Transonic Fan Rotor Blade with a Localized Two-Level Mesh Deformation Method

A stabilized parametric level-set XFEM topology optimization method for thermal-fluid problem

A numerical method for two-dimensional nonlinear transient inverse heat conduction problems for orthotropic material

Three-dimensional topology optimization of thermal-fluid-structural problems for cooling system design

Topology optimization of simplified convective heat transfer problems using the finite volume method

Multi-objective topology optimization of heat transfer surface using level-set method and adaptive mesh refinement in OpenFOAM

The Cut-Cell Method for the Conjugate Heat Transfer Topology Optimization of Turbulent Flows Using the "Think Discrete–Do Continuous" Adjoint

An efficient topology optimization method for steady gas flows in all flow regimes

Thermofluid topology optimization for cooling channel design

Topology optimization of surface flows

Concurrent optimization of the internal flow channel, inlets, and outlets in forced convection heat sinks

A "poor man's" approach for high-resolution three-dimensional topology optimization of natural convection problems

A synergic topology optimization approach on distribution of cooling channels and diverse-intensity heat sources for liquid-cooled heat sink

Topology Optimization of Turbulent Flow Cooling Structures Based on the k-ε Model

Flow–heat topology optimization of internally cooled high temperature applications using a voxelization approach for domain initialization

An approach for topology optimization of heat sinks for two-phase flow boiling: Part 1 – Model formulation and numerical implementation

Topology optimization of fluidic flows on 2-manifolds

An isogeometric analysis-based topology optimization framework for 2D cross-flow heat exchangers with manufacturability constraints

Topology Optimization of Planar Heat Sinks Considering Out-of-plane Design-Dependent Deformation Problems