Abstract:In the current study, a series of laboratory triaxial loading and unloading experiments were conducted for the purpose of comprehensively understanding the effects on sandstone of loading processes under axial stress conditions and unloading processes under confining pressure conditions. The mechanical properties and crack propagation behaviors of sandstone specimens were analyzed. In addition, a new damage variable based on crack evolution was proposed. The experimental results showed that the strain-softening modulus of the sandstone specimens under triaxial loading and unloading compression conditions decreased with the increases in the loading rate. Meanwhile, the elastic modulus was only observed to undergo small changes. This study found that with the increases in the loading rates of axial stress, the deformation and strength levels of the sandstone specimens also increased. In addition, the crack initiation stress showed a linear increasing trend with the increases in the loading rates of axial stress. The peak crack volumetric strain displayed a slight increase with the loading rate of axial stress, which indicated that the larger the loading rate of axial stress on the sandstone specimens was, the smaller crack propagation strain levels at the peak stress levels would be. The crack propagation velocities were observed to be larger when the loading rates of axial stress were higher. Also, at the same loading rate of axial stress, the crack propagation velocity corresponding to the peak stress of the volumetric cracks was the largest, followed by radial cracks. The crack propagation velocity of the axial cracks was determined to be the smallest. In this study, a new crack damage variable based on crack volumetric strain was proposed. According to the evolution of the crack damage variables of the sandstone specimens, the following four stages of the failure process were obtained: original damage stage; elastic stage; linear damage stage; and accelerated damage stage. The results obtained in this research study provided an important scientific basis for the support of future designs and safety protection measures in underground mining operations.

Damage characteristics of sandstone with different crack angles subjected to true triaxial cyclic loading and unloading

Three-dimensional Discrete Element Simulation of the Triaxial Cyclic Loading of Sandstone Based on a Nonlinear Parallel-Bonded Stress Corrosion Model

Study on the mechanical properties of unloading damaged sandstone under cyclic loading and unloading

Experimental study of energy dissipation characteristics and crack coalescence modes of cracked sandstone under different cyclic loading paths

Damage of Sandstone Induced by Repetitive Impact Loading

Study on Dynamic Loading Characteristics and Energy Evolution of Sandstone with Double Cracks

Dynamic Failure Characteristics of Sandstone Containing Different Angles of Pre-Existing Crack Defects

Uniaxial Compression Testing of Sandstone under Microscope: Damage Characteristics and Failure Mechanisms

Effect of Triaxial Loading and Unloading on Crack Propagation and Damage Behaviors of Sandstone: An Experimental Study

Damage evolution and failure characteristics of red sandstone with prefabricated crack under coupled dry-wet cycle-fatigue loading

Crack Propagation and Fragmentation Characteristics of Single-Flawed Sandstone Samples under Different Loading Conditions

Progressive damage and fracture behavior of brittle rock under multi-axial prestress constraint and cyclic impact load coupling

Effects of prior cyclic loading damage on failure characteristics of sandstone under true-triaxial unloading conditions

Study on Progressive Damage and Failure of Sandstone Samples subjected to Cyclic Disturbance Loads using a Modified Triaxial Test System

Experimental investigation on True Triaxial Deformation and Progressive Damage Behaviour of Sandstone

An Experimental Investigation of the Progressive Failure of Sandstone and Its Energy Evolution Characteristics

Experimental and numerical study on the mechanical behaviors and crack propagation of sandstone containing two parallel fissures

Discontinuous fracture behaviors and constitutive model of sandstone specimens containing non-parallel prefabricated fissures under uniaxial compression

Mode-I failure and mechanical behavior of sandstone under cyclic loading: Laboratory testing and DEM simulation

Energy Evolution and Fractal Characteristics of Sandstones Under True Triaxial Cyclic Loading and Unloading

Damage deterioration mechanism and damage constitutive modelling of red sandstone under cyclic thermal-cooling treatments