Abstract:Fractures in natural rocks have an important effect on the strength and failure behavior of rock mass, which are often evaluated in rock engineering practice. The theoretical evaluation of mechanical behavior of fractured rock mass has no satisfactory answer due to the role of confining pressure and crack geometry. Therefore, in this paper, conventional triaxial compression experiments were carried out to study the strength and failure behavior of marble samples with two pre-existing closed cracks in non-overlapping geometry. Based on the experimental results of a number of triaxial compression tests, the effect of crack coalescence on the axial supporting capacity and deformation property were investigated with different confining pressures. The results show that intact samples and flawed samples (marble with pre-existing cracks) have different deformation properties after peak stress, which change from brittleness to plasticity and ductility with the increase of confining pressure. The peak strength and failure mode are found depending not only on the geometry of flaw, but also on the confining pressure. The strength of flawed samples shows distinct non-linear behavior, which is in a better agreement with non-linear Hoek–Brown criterion than linear Mohr–Coulomb criterion. For a kind of rock that has been evaluated as a Hoek–Brown material, a new evaluation criterion is put forward by adopting optimal approximation polynomial theory, which can be used to confirm more precisely the strength parameters (cohesion and internal friction angle) of flawed samples. For intact samples, the marble leads to typical shear failure mode with a single fracture surface under different confining pressures, while for flawed samples, under uniaxial compression and a lower confining pressure (σ3=10MPa), tests for coarse and medium marble (the coarse and medium refer to the grain size) exhibit three basic failure modes, i.e., tensile mode, shear mode, and mixed mode (tensile and shear). Shear mode is associated with lower strength behavior. However, under higher confining pressures (σ3=30MPa), for coarse marble, the axial supporting capacity is not related to the geometry of flaw. The friction among crystal grains determines the strength behavior of coarse marble. For medium marble, the failure mode and deformation behavior are dependent on the crack coalescence in the sample. The present research provides increased understanding of the fundamental nature of rock failure under conventional triaxial compression.

Mechanical Behavior, Mesoscopic Properties and Energy Evolution of Deeply Buried Marble During Triaxial Loading

Analysis on Mechanical Behavior and Progressive Failure of Deep-Buried Marble Based on Complete Stress-Strain Curves

Strength, Deformability and X-Ray Micro-Ct Observations of Deeply Buried Marble under Different Confining Pressures

Experimental Study of Mechanical Properties of Marble under Triaxial Unloading Confining Pressure after Fatigue Loading

Experimental and Damage Constitutive Study of the Stress-Induced Post-Peak Deformation and Brittle–ductile Behaviours of Prismatic Deeply Buried Marble

Numerical investigation on the mechanical and fracture behaviors of marble under cyclic loading and unloading true triaxial compression using discrete element method

Evolution Mechanism and Quantitative Characterization of Initial Micro-Cracks in Marble under Triaxial Compression

Deformation Behavior Of Jinping Marble Under Isotropic Compression And Deviatoric Stress Loading Conditions

True Triaxial Test and PFC3D-GBM Simulation Study on Mechanical Properties and Fracture Evolution Mechanisms of Rock under High Stresses

Post-peak Deformation and Failure Behaviour of Jinping Marble under True Triaxial Stresses

Experimental Investigation on Deformation Failure Characteristics of Crystalline Marble under Triaxial Cyclic Loading

The Mechanism of Low Strain Rate and Moderate Principal Stress Effects in Triaxial Prestressed Marble under Lateral Impulsive Load

STUDY ON THE DEFORMATION FAILURE AND ENERGY PROPERTIES OF MARBLE SPECIMEN UNDER TRIAXIAL COMPRESSION

Experimental Investigation on Strength and Failure Behavior of Pre-cracked Marble under Conventional Triaxial Compression

Experimental Investigation on Deformation and Strength Behavior of Marble with the Complex Loading-Unloading Stress Path

Fracture Evolution and Energy Characteristics During Marble Failure Under Triaxial Fatigue Cyclic and Confining Pressure Unloading (FC-CPU) Conditions

Dynamic Mechanical Behaviors of Interbedded Marble Subjected to Multi-Level Uniaxial Compressive Cyclic Loading Conditions: an Insight into Fracture Evolution Analysis

Brittle-ductile Transition and Failure Mechanism of Jinping Marble under True Triaxial Compression

STUDY OF MECHANICAL BEHAVIOR OF DEEP-BURIED MARBLE AT JINPING Ⅱ HYDROPOWER STATION

Numerical Investigation on the Fracture and Mechanical Behaviors of Marble Containing Two Parallel Fissures under Triaxial Compression Conditions Using FDEM

Time-Dependent Deformation Behaviour Of Unloading-Fractured Marble