Abstract:This paper presents a numerical model to study the process of vapor condensation on surfaces characterized by film-wise condensation with the presence of Non-condensable gases (NCG). State variables in both the condensate film and the diffusion layer were solved separately and the condensation interface was used to couple the two solutions. The solution of the condensate film was obtained using well-established solutions of laminar film condensation of pure vapor. In contrast to other models surveyed, this work provides a inexpensive and accurate predictions of heat and mass transfer characteristics. We validated the work against two classical condensation problems. The model was first validated against empirical correlations and experimental work, resulting in a very good agreement. We then assessed the applicability of ignoring the condensate film effect, as performed in previous models, on the condensation processes by observing the thermal resistances of both the condensate film and diffusion layer. Results indicated that for the studied cases of NCG mass fractions above 20%, the condensate thermal resistance was at least an order of magnitude lower than that of the diffusion layer. However, the two thermal resistances seem to approach each other as NCG mass fraction becomes smaller. On another front, we observed that models that ignore the condensate film thermal resistance underestimate the interfacial temperature albeit accurately predicting the overall heat transfer rate. To simulate even lower NCG mass fractions, we validated our model to the classical analytical work of Sparrow and co-workers. Results showed a striking agreement between the two solutions at different NCG mass fractions (0.5%–10%) and subcooling degrees (5∘F–40∘F). Finally, we found a good agreement between results of our model and the heat/mass transfer analogy. The heat/mass transfer analogy is a semi-empirical method therefore, is limited to the existing correlations and their uncertainties. On the other hand, our model does not use any empiricism and relies on the available solutions of laminar condensate film of pure vapor in predicting the liquid side heat transfer coefficient.

Development and Evaluation of Mass Transfer Model for Film Condensation Simulation

Determination of Mass Transfer Coefficient for Condensation Simulation

Development of a modified thermal phase change model based on the interfacial area concentration determined by an interface reconstruction algorithm

Numerical modeling of vapor condensation over a wide range of non-condensable gas concentrations

Thin liquid film flow and heat transfer under spray impingement

Effects of Liquid Film Waviness, Suction, and Fog Formation on Condensation in the Presence of Noncondensable Gases

Model development and simulation on dropwise condensation by coupling absorption theory in the presence of non-condensable gas (NCG)

Numerical modeling and experimental validation of heat and mass transfer inside charge air coolers with water condensation

Numerical investigation of the thermal performance of a loop thermosyphon considering dynamic condensation mass transfer time relaxation parameter

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Experimental Validation of an Analytical Condensation Model for Application in Steam Turbine Design

Numerical Simulation on Heat and Mass Transfer of Plate Evaporative Condenser

Heat transfer characteristics in vertical tube condensers: Experimental investigation and numerical validation

The Tip of the Iceberg: How Pipette Tips Influence Results

Numerical Investigation of Heat Transfer and Development in Spherical Condensation Droplets

Theoretical Modeling of Vapor Condensation in the Presence of Noncondensable Gas on a Horizontal Tube

Numerical simulation of condensation from isobutane vapour – air mixture

Numerical Investigation of Convective Condensation with the Presence of Non-Condensable Gases in A Vertical Tube

Film Condensation Heat Transfer on a Vertical Porous-Layer Coated Plate

Modeling Study on Heat Transfer in Marangoni Dropwise Condensation for Ethanol-Water Mixture Vapors

Modelling of evaporative falling-film heat transfer over a horizontal tube